Warranty
6
oor is level, proceed with the installation. If the oor is not level, the full bottom of the bath must be seated in mortar. Following the
manufacturer’s instructions, prepare and spread an even layer of mortar between the sub-oor and the full bottom of the bath. With
the drain in the bath aligned with the drain in the oor, being careful not to damage the bath or the components, put the bath in place.
Gently shift the bath until the bedding attens to support the full bottom of the bath and the bath lip rests on the ledger board or
platform frame. Place a level from front to back and side to side to conrm the bath is level. Do not apply weight to the rim or bottom of
the bath and do not ll the bath until the bedding has hardened completely. The enclosure can be insulated and when the bedding is
dry. Keep insulation at least 8” from the components to prevent overheating.
PLUMBING CONNECTIONS
Important: Risk of damage to bath bottom and sub-oor. It is the installer’s responsibility to ensure watertight seal on installed
connections.
Important: Proper installation of the hardware and compliance with codes is the responsibility of the installer. Signature Bath does not
warrant connections of water supply ttings and lines, ll systems, or drain/overow systems and is not responsible for damage to the
bath that occurs during installation.
Connect the supply lines. Close the bath drain, turn on hot and cold water, check supply lines for leaks as bath lls. Turn the water o
when the bath is lled approximately halfway. Let stand for 10 minutes and check for leaks as the bath drains.
FINISH WALL AND INSTALL BATH ENCLOSURE:
With the drain plugged and the bath surface protected, follow the manufacturer’s instructions to mount anges, cover framing with
wallboard, install wall nishing treatments and bath enclosure, seal the space between the bath and the walls, oors, platforms and
enclosures.
CLEANING AFTER INSTALLATION
• To prevent clogging the drain, remove debris and wallboard dust before rinsing your bath.
• Remove large plaster spills with a plastic edge. Metal will scratch the surface.
• Small spots can be removed by rubbing with a soft, damp cloth.
• Paint and other dicult stains that are not water soluble can be removed with paint thinner, rubbing alcohol or turpentine.
• Minor scratches that do not penetrate the surface can be removed with a light sanding with 600 grit wet/dry sandpaper.
• Bu area with automotive bung compound followed by automotive paste wax.
• Major scratches and gouges require renishing. Contact your dealer for special instruction.
OPERATING INSTRUCTIONS
DANGER: Risk of accidental injury or drowning. Do not permit children to use this bath unless they are closely supervised by a
6