Use and Care Manual

10
Fan Blade and Front Grill Cleaning:
(Take off front/reinstall grill method)
To remove for cleaning:
As the detail on the left shows, hold bottom of
front grill and pull out.
When latch releases from front panel, lift front
grill approximately 30 degrees.
Pull front grill away from unit in a parallel
motion.
To reinstall after cleaning:
Place top latch of grill in front panel opening.
Push bottom latch of grill into bottom slot.
Cleaning Information:
Wipe off fan blade and front grill with damp washcloth. The fan requires no
maintenance.
REPLACING THE FUSE
A fuse holder is located on the back of the unit next to the power cord.
To replace or check the fuse:
Remove the fuse holder by pressing on the clip and pulling straight out.
If the fuse is blown:
Replace with the standard replacement fuse. Insert the new fuse into the fuse holder.
Press the assembly straight in until it latches.
120 volt models: Fuse rated at no more than 1.0 Amp.
CAUTION!
If the fuse holder cap is not installed correctly,
the unit will not operate.
7
Notes:
For maximum control, the unit should be placed where easy access to the control
panel is possible.
The rear of the unit should always have at least six inches of open area to allow
unrestricted airflow.
To prevent injury, be sure power cord is not accessible to small children.
CAUTION!
During Ozone mode this unit should never be placed where
it can blow directly into the face of any person or pet.
LCD Display
No Name LCD display
1
Fan working
status
1 to 5 bars will be illuminated to indicate fan speed.
2
HIGH purifying
reminder
When the coverage area is more than 2400 sq. ft, the
LCD display will show HIGH.
3
Coverage area
It displays 1000- 3000 sq. ft. when working; the cover-
age area changes by 200 sq. ft. each time the FAN and
PURIFY button(s) are pressed.
Timing reminder
When the timing function is turned on, the countdown
clock, purified area and timer will be displayed.
Standby
Display will read 0000 and the LCD backlight will turn
off at the same time.
4
FT
2
/ HRS
Display indicates the square foot covered. When set to
“AWAY” the display will flash between HRS and FT
2
.
5
Ozone function
reminder
LCD displays “AREA MUST BE UNOCCUPIED”
when ozone is on. (Note: ozone has obvious effects on
killing germs and removing odors, however, excess
ozone can have adverse health effects, therefore, it
should be used in unoccupied spaces only)
6 Mode
Will display; NORMAL (1~5), HIGH (1~3), AWAY
(1~3) according to different working settings and puri-
fied area settings.