Use and Care Manual

8
No Name Function and operation instruction
1 POWER
Stand by mode: Unit will turn on when the Power button
is pressed. Press Power again to turn unit off.
2 SLEEP
Press one time: 1200 sq. ft. SLEEP mode.
Press second time: 1000 sq. ft. SLEEP mode.
LCD display, UV bulb and ozone generator are off during
SLEEP mode. Press any button to exit SLEEP mode.
3 FAN UP
To increase the fan speed press FAN UP (Note: Coverage
area changes by 200 sq. ft. each time button is pressed).
4 FAN DOWN
To decrease the fan speed press FAN DOWN (Note: Cover-
age area changes by 200 sq. ft. each time button is pressed).
5
PURIFY
DOWN
To decrease the ozone output, press PURIFY DOWN (Note:
Coverage area changes by 200 sq. ft. each time button is
pressed).
6 PURIFY UP
To increase the ozone output press PURIFY UP (Note: Cover-
age area changes by 200 sq. ft. each time button is pressed).
7 TIMER
1)Press TIMER button, clock will display 0:00
2)Press PURIFY UP within 2 seconds to adjust run time. Time
will increase by 0.5H each time the button is pressed; maxi-
mum run time 9.5H, minimum run time 0.5H
3)When the time setting is finished, it enters automatic shut off
mode, and back to normal working mode before time setting.
8 AWAY
Air purifier works at maximum function on AWAY mode.
Press one time: shut off after 0.5H；Press second time, shut
off after 1hr；Press third time, shut off after 2hr; Press again to
return to manual mode.
Remote control function and description
9
9 OZONE
Press to turn ozone on and off.
Note: PURIFY does not work if ozone is off (Note: Ozone
can only be used in an unoccupied space).
10 UV
Press to turn UV on or off.
MAINTENANCE
Periodic maintenance is required to ensure that your Mountainaire Air
Purifier operates properly. A severely polluted environment can foul an air
purifier plate in as little as four weeks or as long as a year. Shown here are
basic maintenance procedures that should be carried out to keep your unit
running at top performance.
Pre-Filter/HEPA Filter Cleaning:
(Turn to page 5 for removal instructions)
You have two options to clean filters:
When filter is visibly dirty, simply remove the pre-filter or HEPA filter
and clean the heavy particulate from the screen with a hand-held vac-
uum. This method will extend the life of the screen/filter.
When filter is visibly dirty, remove the filter from the unit and wash it in
cool water, brush it gently with a toothbrush to remove particulate. Dry
completely prior to re-installing.
CAUTION!
Always ensure the room or area is UNOCCUPIED
before operating the above-described Ozone control.