Use and Care Manual

(Front)
(Back)
User Guide
MBOT3003
Installing Remote Control Batteries
1. Unscrew the screw that secures the battery cover on the
back of the remote control with the included screw driver.
Remove the battery cover.
2. Install the 2 included AAA-sized batteries following the
polarity (+/-) diagram in the compartment. If you are
replacing the batteries, use new Alkaline batteries, and do
not mix old and new batteries, or different types or brands
of batteries.
3. Replace the battery cover, and screw the screw back in.
Manual Control Mode
To control the cleaner manually with the Direction Buttons:
1. Power the cleaner ON.
2. Press the [ M ] button (3) on the remote control until Manual
Control mode is selected.
3. Press the Direction Buttons on the remote control
to move the vacuum cleaner as desired.
Remote Control Troubleshooting
If you are having problems with the remote, try checking the
following:
1. The battery power of the remote control. If the LED indicator on
the remote control does not flash when a button is pressed, the
remote control’s batteries may be low or dead.
2. The battery power of the vacuum cleaner.
3. That the vacuum cleaner and remote control are not too far
apart. The remote control only works within a certain distance of
the vacuum cleaner.
4. That the vacuum cleaner’s [Power] switch is in the ON position.
Location of Controls
Remove any protective covering
from the remote control before
using.
1. Direction Buttons:
In Manual Control mode (see
Manual Control Mode section
of this manual) move the
vacuum cleaner forward,
backward, left or right
2. [ ] Button:
Pause/restart
3. [ M ] Button:
Switch between modes:
1. Automatic Cleaning Mode (Default)
2. “U”-Shaped Cleaning Mode
3. Spot Cleaning Mode
4. Manual Control Mode
4. [ ] Button:
Turn LED Lights ON/OFF
5. LED Indicator
Cleaning & Maintenance
The vacuum cleaner collects dust and debris in its dust box.
To keep the vacuum cleaner in good working order, the dust
box & filter should be cleaned regularly.
To clean the dust box & filter:
Getting Started
Caution
To ensure safe and proper use, read all safety information before using the
device. Only use with manufacturer-approved batteries, chargers,
accessories, and supplies.
• READ ALL INSTRUCTIONS CAREFULLY BEFORE USE AND
KEEP THIS MANUAL FOR FUTURE REFERENCE.
• THIS IS NOT A TOY, Please keep away from children.
• Only use the device according to the instructions in this manual.
Never use the device for anything other than its intended
purpose.
• Low power may cause dysfunction.
• Do not overcharge the battery.
• Do not expose the unit to extreme temperatures (heat or cold),
open flames, humid conditions, or wet conditions.
• Do not submerge in water, and do not use the vacuum cleaner
to clean up water or any other liquid.
• Do not open this product or attempt to repair the unit yourself
should it not be working.
• Do not allow any ports, inputs or vents of the device to be
exposed to dust, or water, or come into contact with any
conductive materials such as liquids, metallic powders, etc.
• This device contains a built-in battery and should not be disposed
of with regular household waste. Please consult the local
authorities on the correct way to dispose of this device.
Questions & Support
If you have any questions or problems concerning this
product, please visit our website at SouthernTelecom.com
and click on Product Support.
In the Box
• MBOT3003 - 3-in-1 Vacuum Cleaner (x1)
• USB Charging Cable (x1)
• Remote Control (x1)
• Screw Driver (x1)
• AAA Batteries (x2)
• Brushes (x5)
• Mopping Strip (x1)
• Adhesive Strips (x2)
• User Manual (x1)
Compliance Information Warranty Information
FCC Information
This device complies with Part 15 of the FCC Rules.
Caution: Any changes or modifications not expressly approved could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Radiation Exposure Information
This device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
WARNING Li-ion Battery Inside
This product is fitted with a Li-ion battery. Do not damage,
open, or dismantle the battery and do not use it in damp
and/or corrosive conditions. Use only with compatible
chargers. Never dispose of batteries in a fire, and never
expose them to high temperatures. Do not expose the
product to temperatures exceeding 60°C (140°F).
Rating Label Denitions
Before You Begin...
Location of Controls
This symbol signifies that the product must not be discarded as
household waste, and should be delivered to an appropriate collection
facility for recycling. Proper disposal and recycling helps protect
natural resources, human health and the environment.
This symbol represents FCC Declaration of Conformity and compliance.
This symbol signifies and declares that this equipment complies with
battery charging which complies with California CEC and energy
efficiency.
Direct current symbol
Mopping
Cloth
Balancing
Wheels
Sweeping
Brushes
Charging Port
(Side of
Cleaner)
Locomotive
Wheels
Bottom of
Vacuum Cleaner
Top of Vacuum
Cleaner
Battery
Cover
[Power]
Button
Top Cover
(Dust Box)
Powering ON/OFF
Charge the vacuum cleaner fully before using.
• Flip the [Power] switch on the bottom of the vacuum
cleaner to power ON. Press the [Power] button on the top
of the vacuum cleaner to begin cleaning. The vacuum
cleaner will power ON in Automatic Cleaning mode. The
LED indicator will light up.
• Press the [Power] button to power OFF.
• The vacuum cleaner does not have an automatic shutoff
function, so you will need to flip the [Power] switch to turn
the vacuum cleaner off when you are done using it. Never
leave operating unattended, especially around children or
pets. Do not leave operating while you are not home.
Using the Vacuum Cleaner
The vacuum cleaner is best used on a smooth surface, or on
short carpet. Be sure to test the vacuum on an inconspicuous
area of carpet before using to prevent damage to carpet.
Caution: The vacuum cleaner should only be used on
certain surfaces.
• Keep away from stairs, clothes, uneven surfaces and
electronic cables. The vacuum cleaner should be used on
flat surfaces not taller object than 0.5 cm (0.2 in), lower
than 5.2 cm (2 in), or a 30° incline, or it may get stuck.
• Keep away from liquids & wet surfaces such as a bathroom.
• Keep away from hot, burning or flaming surfaces.
• The above situations risk shock, injury or damage.
1
2
3 4
Remote Control
1. Open the top
cover of the
vacuum cleaner
2. Remove the dust box
3. Open the dust box and remove the filter, as shown below
4. Empty the contents of the dust box into the trash.
Printed in China/Designed in the U.S.
v1. 08/2020
90-day Limited Warranty
Territory: United States/Canada
LIMITED WARRANTY TO ORIGINAL CONSUMER
This product (including any accessories included in the original packaging) as supplied and
distributed new by an authorized retailer is warranted by Southern Telecom, Inc. to the
original consumer purchaser against defects in materials and workmanship (“Warranty”) as
follows:
To obtain warranty service:
• Visit our website at www.southerntelecom.com
• Click on Product Support
• Select the Brand of your device
• Select Service Request and fill out the form to begin your inquiry
Your product will be repaired or replaced, at our option, for the same or similar model of
equal value if examination by the service center determines this product is defective.
Products received damaged as a result of shipping will require you to file a claim with the
carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse, improper
installation or operation, lack of reasonable care, unauthorized modification including
software modifications such as the installation of custom firmware. This warranty is voided
in the event any unauthorized person opens, alters or repairs this product. All products being
returned to the authorized service center for repair must be suitably packaged.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO,
ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY.
DISTRIBUTOR FURTHER DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS
WARRANTY PERIOD STATED ABOVE. NO OTHER EXPRESS WARRANTY OR GUARANTY
GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE
BINDING ON DISTRIBUTOR. REPAIR, REPLACEMENT, OR REFUND OF THE ORIGINAL
PURCHASE PRICE - AT DISTRIBUTOR’S SOLE DISCRETION - ARE THE EXCLUSIVE
REMEDIES OF THE CONSUMER. IN NO EVENT WILL DISTRIBUTOR OR ITS
MANUFACTURERS BE LIABLE FOR ANY INCIDENTAL, DIRECT, INDIRECT, SPECIAL,
PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES
FOR LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE,
MISUSE OR INABILITY TO USE THE PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER
WARRANTIES SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMER’S
RECOVERY AGAINST DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE
PRODUCT SOLD BY DISTRIBUTOR. THIS WARRANTY SHALL NOT EXTEND TO ANYONE
OTHER THAN THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT
TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation of incidental or
consequential damages or allow limitations on warranties, so limitation or exclusions may
not apply to you. This warranty gives you specific legal rights, and you may have other rights
that vary from state to state or province to province. Contact your authorized retailer to
determine if another warranty applies.
All product names, trademarks, and registered trademarks are property of their
respective owners. All company, product, and service names used in this document are
for identification purposes only. Use of these names, trademarks, and brands does not
imply endorsement.
Instructions continued on next page.
Cleaning & Maintenance (cont’d)
5. For extra deep
cleaning, wipe the dust
box out with a dry or
damp cloth. Make sure
to dry it completely.
6. Clean the filter by blowing clean with a hair dryer, or by
brushing clean with a soft brush.
7. Finally, replace the filter and dust box lid. Snap the dust
box back into the vacuum cleaner.
Additional Cleaning
The vacuum cleaner’s wheels, suction port and sweeping
brushes will also gather dust and hair regularly. Remove
difficult debris by hand if necessary, then brush clean or wipe
with a dry cloth.
The outside of the vacuum cleaner, as well as the remote
control, may be cleaned with a dry or damp cloth. Never
bring the vacuum cleaner or remote control into contact
with liquid. Never submerge in water or liquid.
Storage
If the vacuum cleaner will not be used for a long period of
time, it is best stored in an airtight box or bag (not included),
away from sources of heat, light, moisture and dust.
LED
Lights
[Power]
Switch
Remote Control (cont’d)
Troubleshooting
Common Issues & Solutions
The cleaning is weak.
1. Power OFF. Check that the dust box, suction port and
sweeping brushes have all been cleaned, and are free of
debris. Check that the filter does not need to be replaced.
2. Check that vacuum cleaner is fully charged.
The vacuum cleaner won’t charge.
1. Make sure both connectors of the charging cable are
correctly connected. Both connect in only one direction.
2. Make sure that the cable is not damaged. If the cable is
damaged, do NOT attempt to charge. Contact the
manufacturer immediately.
3. Make sure that you are plugged into a compatible
5-Volt/1-Amp USB-A power source. If the power source is
not working or connecting correctly with the device, the
vacuum cleaner won’t charge.
4. Make sure you have waited several minutes after plugging
the vacuum cleaner in to see that it won’t start charging.
The LED indicator will light up RED when the vacuum
cleaner is charging.
The machine becomes very noisy while cleaning.
Make sure that the dust box, filter and sweeping brushes are
all clean and in working order.
The machine is stuck, or stops working. An alarm sound
may be heard.
Check to make sure that the wheels are not stuck. Check that
nothing is stuck around the wheels or in the suction port. If
the vacuum cleaner has run over cables, curtains, long carpet,
beads or any other obstacles, these may clog and/or damage
the vacuum cleaner.
The remote control isn’t working.
Please see the Remote Control Troubleshooting section
under the Remote Control instruction portion of this manual
for instructions on this topic.
5
“U” Shaped
Intelligent Mode
Spot Cleaning
Mode
Tile Floor Wooden Floor Marble Floor Felt Carpet
Bumper
Setting Up
1. Remove the 2 included sweeping brushes from the box.
Press them onto their places on the bottom of the vacuum
cleaner, as shown below. Make sure they click on securely,
as any gap can cause a malfunction of the vacuum cleaner.
2. To use the
included mopping
cloth, wet the
cloth slightly so
that it is damp
(not wet). Mount
the mopping cloth
onto the bottom of the vacuum
cleaner using the 2 included
adhesive strips. *Note: use the
moppingcloth on smooth floors only, NOT on carpet.
Charging the Vacuum Cleaner
Note: When the vacuum cleaneris low on battery, a tone will
be heard and its LED indicator will flash BLUE. Please
recharge when this happens.
Plug the small, round
connector of the supplied
charging cable into the
charging port on the side of
the vacuum cleaner. Plug
the large connector into the
USB port on a computer or
into a compatible USB
adapter (not included) and
plug into a wall socket.
The LED indicator will turn
RED when the vacuum cleaner is charging and turn OFF
when fully charged.
Please note:
• For best battery life, do not use while charging.
• Charge for 3-5 hours for a completely full charge.
• The battery cleaner will not reach its fullest charge until after
its first 2-3 full discharges & recharges.
Note: When a button on the remote control is pressed,
the LED indicator will flash. If the LED indicator does
not flash, the remote control’s batteries may be low or
dead, or not installed correctly. If this happens, please
check the remote control batteries.
Instruction Guide
MBOT3003
Smart Robotic
3-in-1 Vacuum Cleaner