Manual

Operation
1 Lid (frothing attachment is on the underside)
2 MAXmarkformaximumlling
3 Stainless steel tank
4 Status LED
5 Power button (on/off)
6 Base with mains plug
7 MAX mark (stirring)
8 MAX mark (frothing)
9 Mixer insert (frothing or stirring)
Clean the device after each use.
Always use fresh milk.
Do not repeatedly froth or stir up old contents.
 Thedevicewillswitchononlyifitiscorrectlypositionedonthebase.
A LED above the button indicates when the device is switched on.
Always switch off the milk frother before removing it from the base.
 Donottouchthedeviceduringoperationin“heatingup”modeasitgetsveryhot.
Always grab the milk frother by the handle.
After use, unplug the device from the mains socket.
Do not leave the running device unattended.
Cleaning
Always disconnect the device from the mains supply before cleaning.
Pull the plug out of the mains socket.
• Allow the device to cool down before cleaning.
• Never clean the milk frother or the base by immersing them in liquids such as water.
• Allow the device and power cord to dry before you use them again.
• Never use any aggressive, abrasive cleaning agents, abrasive wire brushes or abrasive
objects for cleaning.
• Wash the milk tank and the lid with warm soapy water and then rinse with clean water. Wipe it
dry with a soft towel after each use.
• Takethestirringinsertoutofthetankandwashitwithwarmwater,thendryitandstoreina
safe place. Do not clean it in the dishwasher.
• You can use a damp cloth to wipe the outside of the device.
Troubleshooting
Device produces strange noises:
Check whether the whisk (stirring insert) has been inserted correctly (magnet below).
Milk froth spills over the tank:
Toomuchmilkinthetank.
Check that the correct attachment is being used.
Degraded milk froth quality:
Use whole or low-fat milk at a temperature of approx. 4-6 °C
Check that the correct attachment is being used.
Check the device for cleanliness.
The socket fuse trips:
Thepowercircuitisoverloaded.Checkwhetherotherconsumerswithhighpowerconsumption
such as coffee machine (in operation) are connected to this power circuit.
Disposal
Electronic devices are recyclable waste and must not be placed in household waste.
At the end of its service life, dispose of the product according to the relevant statu-
toryregulations.Youthusfullyourstatutoryobligationsandcontributetoenviron-
mental protection.
Specications
Voltage.......................................... 220– 240 V~
Mains frequency ........................... 50 – 60 Hz
Power consumption ...................... 500 W
Protection class ............................I
Capacity ........................................ max. 125/400 ml
Weight .......................................... 880 g
 Cleanthedevicebeforeusingitforthersttime.Moredetailscanbefoundinsec-
tion“Cleaning”.
• Unpack the device and check it for damage.
• Remove all packaging materials and dispose of them properly.
• Place the base (6)onaatworksurface.
• Check whether the desired mains voltage matches that of your device. Relevant information
canbefoundinthismanualunderspecications.
• Connect the base to the mains voltage.
• Theinsertconsistsoftwoparts(mixingunitandwhisk),whichcanbecombineddepending
on the mode (see illustration).
Use the frothing attachment. It can be found on the underside of the lid. Remove the attach-
mentandplaceitonthestirringattachment.Thenplacethecompleteunitontotheshaft(9)
at the bottom of the tank.
Replacement of attachments must always take place in de-energised condition, with
the device removed from the base.
Frothing (tank capacity approx. 125 ml)
Stirring (tank capacity approx. 400 ml)
• Placethemilkfrotheronthebase.Themilkfrothermustsitrmlyinthecontactfootofthe
base.
• Fill the milk frother with the desired amount of skimmed or semi-fat cold milk (4-6 °C).
 Infrothingmode,neverllthedeviceuptoorabovethelowerMAXmark(approx.
125 ml). If there is too much milk, it can spill over the tank as it expands during
frothing.
• Put the lid on the device.
• When using heating upmode,brieypressthepowerbutton(powersymbol).TheLED
abovethebuttonlightsup“red”.Therunningtimeisapprox.80-90s.
• For preparation without heating,pressandholddownthepowerbuttonfor2seconds.The
LEDabovethebuttonlightsup“blue”.Therunningtimeisapprox.120s.
• TheLEDabovethebuttonlightsupaslongasthedeviceisinoperation.
• Theprocesscanbeinterruptedbypressingthepowerbutton,afterwhichtheLEDgoesoff.
• After process completion, open the lid and lift it off.
• Graspthestainlesssteeltankbythehandle.Thetankgetshotin“heating”mode.
• Pour or scoop the milk froth into the drinking vessel.
• After preparation, rinse the stainless steel tank with clean water.
Cocoa/instant beverages
Use the milk frother to prepare milk, cocoa or instant beverages (cold or warm).
• Use the stirring attachment.
• Putallnecessaryingredientsinthetank.Observetheupper“MAX”mark.
• Put the lid on the device.
• When using heating upmode,brieypressthepowerbutton(powersymbol).TheLED
abovethebuttonlightsup“red”.Therunningtimeisapprox.220s.
• For preparation without heating,pressandholddownthepowerbuttonfor2seconds.The
LEDabovethebuttonlightsup“blue”.Therunningtimeisapprox.120s.
• TheLEDabovethebuttonlightsupaslongasthedeviceisinoperation.
• Theprocesscanbeinterruptedbypressingthepowerbutton,afterwhichtheLEDgoesoff.
• After process completion, open the lid and lift it off.
• Graspthestainlesssteeltankbythehandle.Thetankgetshotin“heating”mode.
• Pour or scoop the milk froth into the drinking vessel.
• After preparation, rinse the stainless steel tank with clean water.
ThisisapublicationbyConradElectronicSE,Klaus-Conrad-Str.1,D-92240Hirschau(www.conrad.com).
Allrightsincludingtranslation reserved. Reproduction by anymethod,e.g.photocopy, microlming, or the capturein
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
Thispublicationrepresentthetechnicalstatusatthetimeofprinting.
©Copyright2021byConradElectronicSE. 2362833_V1_0621_02_m_VTP_en