Instructions / Assembly

WARNING: Shut off the power supply before removing or
replacing lamp. In handling of halogen bulb, care should be taken
not to touch it with your bare hands. Oil residue will shorten the life
of the halogen bulb. If you accidentally come into contact, wipe
thoroughly with a clean, lint-free, cotton cloth. Allow the bulb to
cool off for 10 minutes before changing the bulb. Use light bulb in
accordance with the fan's specification. TO REDUCE THE RISK
OF FIRE DO NOT EXCEED MAXIMUM WATTAGE RATING.
ATTENTION: The Energy Policy Act of 2005 requires this fan to
be equipped with a 190 watt limiting device. If lamping exceeds
190 watts, the ceiling fan's light kit will shut off automatically.
Step 1. Remove 1 of 3 screws from the mounting plate and loosen the
other 2 screws. (Do not remove)
Step 2. Raise and hold the light plate close to the mounting plate
and proceed to do the wire connections. Connect the white wire
connectors from the light plate and fan, follow the same procedure
with the black wire connectors. (Fig. 16)
Step 3. Place the light plate key holes over the 2 screws previously
loosened from the mounting plate, turn light plate until it locks in place
at the narrow section of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously removed. (Fig. 16).
Step 4. Install 100W halogen bulb (included). (Fig. 16).
Step 5. Raise glass shade up against bottom of fan housing and
secure it to fan by twisting glass clockwise until snug. DO NOT
OVERTIGHTEN. (Fig. 16)
Figure 16
Installing the Light Bulb & Glass Shade
100W Halogen
bulb
Screws
Light plate
Glass shade
Bulb socket
Connector
plugs
Mounting
plate