Instructions / Assembly

4.Hanging the Fan
REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1. Attach the mounting bracket to the
outlet box with two screws and washers
provided with the outlet box. Make sure
the bracket is tight and secured. (Fig. 4)
Step 2. Lift fan into position by hanging
the motor assembly onto the hook from the
ceiling mounting bracket allowing it to
hang freely. (Fig. 5)
Outlet box
Mounting bracket
Figure 4
Figure 5
5. Making the Electrical
Connections
Remember to disconnect the power.
Follow the steps below to connect the fan to
your household wiring. Use the wire connecting
nuts supplied with your fan. Secure the
connectors with electrical tape. Make sure there
are no loose strands or connections.
NOTE: The Hand Held Remote or Wall Control
units included with your ceiling fan are
equipped with 16 code combinations to prevent
possible interference from or to other remote
units. The dip switches on your Receiver and
Transmitter units have been preset at the
factory, please re-check to make sure the
switches on both units are set to the same
positions. The frequency settings should be
changed only in case of interference or if a
second or more remote controlled ceiling fans
are installed in the same structure. Any code
combination will operate the ceiling fan and
light as long as the Receiver and Transmitter
units are set to the same codes (Fig. 6)
Step 1 Connect the fan supply (black) wire to
the black household supply wire as shown in
Figure 7.
Step 2. Connect the neutral fan (white) wire to
the white neutral household wire.
Motor