Instructions / Assembly

Operating the Transmitter 10.
Restore power to ceiling fan and test for
proper operation.
1. " LO, MED, HI" buttons:
These three buttons are used to set the fan
speed as follows:
LO= Low speed MED= Medium speed
HI= High speed
2. "FAN OFF" button:
This button turns the fan off.
3. The "LIGHT/DIMMER" button turns the
light ON or OFF and also controls the
brightness setting. Press and release the
button to turn the light ON or OFF. Press
and hold the button to set the desired
brightness. The light key has an auto-
resume, it will stay at the same brightness
as the last time it was turned off.
4.
Warm weather - (Forward) A downward air
flow creates a cooling effect as shown in
Figure 23. This allows you to set your air
conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow
moves warm air off the ceiling area as shown
in Figure 24. This allows you to set your
heating unit on a lower setting without
affecting your comfort.
The "REVERSE" button is used to set the
fan forward or reverse, press the button
forward (for warm weather) or reverse
(for cool weather):
Speed settings for warm or cold weather
depend on factors such as room size, ceiling
height and number of fans, etc.
NOTE: To operate the reverse function on
this fan, press the reverse button while the
fan is running.
Figure 19
LIGHT / DIMMER
LO
MED
HI
FAN OFF
REVERSE
Installing the battery:
Install 9 volt battery (not included), to
prevent damage to transmitter, remove the
battery if not used for long periods.
9 Volt
Batt
ery
Figure 18