Installation Guide

PARTS IDENTIFICATION (CONT.)
Control Panel Operation
SIZE S (SMALL) or L (LARGE):
Press to select the size of ice to make. Choose between size Small and
Large.
ON/OFF:
Press to power unit on or off.
ADD WATER:
This light will turn on along with a beep indicator when the water level is too low. You
will need to add water to the Water Reservoir and press the „Power‟ button twice to restart the ice
maker.
ICE FULL:
This light will turn on with a beep indicator when the ice has reached the maximum
capacity of the storage cabinet. Press the „Power‟ button twice to restart the ice maker after some
of the ice has been removed from the Ice Bucket.
OPERATING PROCEDURES AND MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove all exterior and interior packaging. Check that the ice basket and ice scoop are
included. If any part or accessory is missing, please contact our customer service department.
(Contact information on p. 11)
2. Clean the interior with lukewarm water and a soft cloth. Remove the ice basket and wash it in
warm water.
3. Wipe the evaporator rods clean using a water/vinegar solution.
4. Find a location for your ice maker that is protected from direct sunlight and other sources of
heat (i.e. stove, furnace, radiator, etc...). Place the ice maker on a level surface and make sure
that there is at least 5 inches of space between the back and sides of your ice maker and the
wall.
5.
Allow the refrigerant fluid to settle for several hours before plugging in the unit.
6. The appliance must be positioned so that the plug is accessible.
www.maxi-matic.com
5
[e-mail]