Instructions

Develop your own USB

applications and emulate,

using a single USB cable!

Integrated USB hub and

USB-based power supply

RESET button, for

the target device

Button that invokes the

USB bootstrap loader,

for firmware updates

Pushbuttons and LEDs,

for user interface

eZ-FET emulator

· Open-source

· Works with almost any

MSP430 target

40-pin BoosterPack header

· Compatible with 20-pin and

40-pin BoosterPacks

· Now allows BoosterPacks

with more functionality

Isolation Jumper Block

· Connect to other targets

· Allow more accurate power

measurement

MSP430F5529 USB Microcontroller

· 128KB flash, 8KB RAM

· Full-speed USB

· ADC

· 5 timers

· 4 serial interfaces (SPI, UART, I C)

· Analog comparator

· Much more !

www.ti.com

Hardware

2 Hardware

This section describes the F5529 LaunchPad hardware.

Figure 7 shows the LaunchPad, with its important features and configuration controls. These controls are

described in this section.

Figure 7. EVM Features and Controls

SLAU533A–September 2013–Revised January 2014 MSP430F5529 LaunchPad™ Development Tool (MSP

‑

EXP430F5529LP)

Submit Documentation Feedback