Installation Guide

3
Lift the handle up, the cartridge will be activated allowing water to flow. The water flow will increase by continuing to rotate handle. By rotating the handle to the right, the water temperature will decrease to cold flow only. By rotating Handle to the left, the water temperature will increase to hot only.
6
After installation is complete, remove aerator and rotate
handle to the closed position. Turn on the water supply
valves, and check all connections for a leak. Turn on
your faucet and allow both hot and cold water to run at
least one minute each. Replace Aerator.
Faucet Start Up
Connect hot and cold water supply lines to the Water Supply Valves.
4
INSTALLA
TION PROCEDURES
You should clean all the dirts from valve outlets.
Turning of
f the water supply valves
. This is usually
found near the water mete
r. If you are replacing
an existing faucet, remove the faucet from the sink and clean the sink surface thoroughl
y.
Install without Deck Plate. Make sure the O-RING is placed onto the bottom of Base Ring. Install faucet through hole in sink. From underside sink, put Plastic Washer and Mounting Nut. Position faucet on sink properly and tighten Mounting Nut.
If necessary
, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
2
1
2
3
Unscrew Locknut. Make sure the Rubber Washer in the right position under Flange. Insert Pop-up Assembly into Sink drain Hole. From underneath, tighten with Lockset.
5
7
HOT
COLD
Open
Close
Swing Spout
MAINTENANCE AND C ARE