Instructions / Assembly

WG Wood Products
Installation Instructions
If your product has
adjustable shelving:
For additional help or to watch an installation video for in-the-wall
products, visit our website at www.wgwoodproducts.com
Adjustable Shelf Leveling
Your product has been hand made to the highest
quality possible. It is however, possible that your
adjustable shelves may not sit perfectly level. This
could be due to many factors such as final drying of
the wood causing shrinkage or warping, or even a
slight movement when assembled. All shelf holes are
drilled to within 1/32” of an inch which is extremely
accurate.
If you find that your shelves (glass or wood shelves)
do not sit perfectly level, you can:
•Try turning the spoon shelf rests upside down on one
side. That usually is enough to correct for any
unevenness.
•You can also place a felt dot on top of one or more of
the spoon rests in order to bring the shelf up to level.
Your product will be marked so that you can tell which pieces go where.
There are four pieces to the upper section (two sides, a top and a
bottom). And there are four pieces to the lower section (two sides, a
top (which is also the bottom of the upper section and will already be
screwed together) and a bottom. Start with the upper section pieces
and arrange them to form a “box” with the trim out the outside edges
(holes for the adjustable shelves will be on the inside). Now screw
them together in all four corners making sure the front is flush. Repeat
this procedure for the lower section. Now turn the unit over and nail on
the backer boards. Add your hinges, door and handle and you’re ready
to install!
If your product has multiple sections that
need to be re-assembled:
If your product has a trash can module:
Simply drape any standard small garbage bag or store bag over the
included steel frame and then slide it in on the rails provided and close
the door!