Instructions / Assembly

WG Wood Products
Installation Instructions
For additional help or to watch an installation video for in-the-wall
products, visit our website at www.wgwoodproducts.com
1. There are two magnetic catches, two strike plates, 6 black
screws ½” in length. Screw the magnetic latches into the
sides of the unit using the ½” black screws. These should be
about 1/8” to ¼” from the front of the frame to allow room for
the faceplate.. See photo below. Put the strip through the
last coil of the spring making sure it covers both sides, then
screw it into the back of the cabinet..
2. The strike plates will already be glued to the back of the
faceplate for you.
3. Now insert the platen and your faceplate into the opening
until the strike plates meet up with the magnetic catches.
That will hold the faceplate in position.
4. When it is time to refill, simply pull the faceplate off of its
magnetic catches and load tissues inside in front of the
platen.
If your product has a Tissue
Dispenser:
Some notes on your Tissue Dispenser:
Our tissue dispenser is used in many different products and
performs well under normal circumstances. Our springs were
custom made for this application with the precise amount of tension
needed and were extensively tested over several weeks by our
spring manufacturer to be sure that they would perform as desired
with various brands. DO NOT quickly “rip” the tissues out of the
dispenser. Tissues are very thin and there is enough tension on the
spring that this can cause the tissues to tear. You will find that it
works much better if you gently pull the tissue out of the dispenser.
ALSO, DO NOT overload the dispenser! Generally, a stack about 1
to 1 1/2” high is the maximum capacity for the dispenser to work
correctly. Overloading the dispenser will cause improper operation
because the spring will be compressed too far.
Should you desire to use the tissue dispenser with full boxes of
tissues instead of using the spring mechanism, there are certain
brands and size boxes that will fit inside the unit with the tissue
plate in front of them.