Instructions / Assembly

Installation

Assembling the solar lights

Preparing the solar panels

□ Insert the bottom of the solar light (A) into the top of the

pole (B).

□ Remove the ground stake (C) from the bottom of the

pole (B).

□ Insert the top of the ground stake (C) into the bottom of the

pole (B).

□ Repeat this step for each solar light (A), pole (B), and

ground stake (C).

NOTE: To allow each battery to reach full capacity and

perform correctly, pull out the plastic tab and place the solar

light in full sunlight for the first 12 hours. Failure to do so can

shorten the life of the battery or operation of the light. On

cloudy or rainy days it may take several days for the batteries

to fully charge.

NOTE: To protect the solar panel from damage, do not use

force during assembly. Keep the plastic shades in the

packaging until you need to install them.

□ Twist off the top of the solar light (A) and remove the tab

from the battery compartment (1) located on the underside

of the solar panel top.

□ Twist the top of the solar light back on.

□ Repeat these steps for each solar light.