OS-440 | SET-UP GUIDE Rev 7.1.
OS-440 | SET-UP GUIDE 3 2 5 7 1 4 6 8 9 Overview • OS-440 will enter standby mode after 15 minutes of no use. • OS-440 will wake up from standby mode once music begins streaming. Use the app to wake up the OS-440 when sending music to the analog or optical input. • Source will auto switch to Wi-Fi when music is cast to the OS-440 (requires Wi-Fi Network configuration). 1. Optical Input Port • Port for optical audio input. 2. RCA Input Ports • Ports for RCA analog input. 3.
What’s Included 1. OS-440 Amplifier (QTY 1) 2. Tri-band Wireless Antennas (QTY 2) 3. Euroblock Connectors (QTY 2) 4. Screwdriver (QTY 1) 5. Screws (QTY 8) 6. Zip Ties (QTY 3) Outdoor Weather Kit 7. Front Rubber Seal (QTY 1) 8. Rear Rubber Seal (QTY 1) 9. Speaker Input Plug (QTY 2) 10. Speaker Input Plug (QTY 2) 11. Rear Power Plug (QTY 2) 12.
Physical Setup Guide See online outdoor weather instructions for outdoor installation. 1. Screw the antennas onto the amplifier. 2. Use included screwdriver to open all positions on the euroblock. Be gentle. Stop when you hit resistance, otherwise the euroblock will break. 3. Insert speaker wires according to channel and polarity (Red is positive, black is negative). 4. Tighten screw terminal clamp on the euroblock down onto wire, ensuring a tight fit. 5. Attach euroblock connector to the amp. 6.
Software Specifications Google Chrome Cast Yes Bluetooth Audio Yes DLNA Yes Wi-Fi 802.
5. Tap ‘Next; at the bottom right corner to proceed with the setup of the OS-440. Then, to confirm that the pairing of the OS440 was successful, Google Home will play a sound through the device. If you hear the sound, tap ‘Yes’ at the bottom right corner to proceed to the next step. 6. Once you confirm that the pairing was successful, you will then be prompted to name the OS-440. You can choose from a predetermined list of room names, or input your own. 7.
8. Set up is now complete and you are ready to start using your OS-440. You can now play music through your preferred music platform (Amazon, Pandora, Spotify etc.) by utilizing the ‘Cast’ feature in each program. 9. If you ever need to change the network that your OS-440 is connected to: 9.1. Open the Google Home app and select the OS-440. If you renamed the device in the initial set up or have multiple devices, be sure to select the correct one. 9.2. Tap the ‘...
Section 3: How to Connect a Hardwired Device to Your OS-440 1. Physically plug in your source device using either the RCA (analog) or Optical (digital) input ports. 2. Press the source select button to light the appropriate input you are using; analog or optical. 3. Refer to your input device’s instruction manual for playback functionality. Section 4: How to Configure Your OS-440 on Wi-Fi Direct 1. Go to the Apple App Store or Google Play store and download the amplifier control application “MSE OS-App”.