Instructions / Assembly

A Inflating the Board
1. Unroll the board on a flat surface, ensuring there are no sharp object present that can puncture
the board.
2. Connect the pump hose to the pump. (image 5202)
3. Turn the valve cap counter clockwise to remove the cap.(image 5198)
4. Connect the pump hose to the valve by turning it clockwise to lock into place. (image 5199)
5. Pump the handle of the pump to inflate the paddle board to an ideal pressure of 10 -12 psi. DO
NOT EXCEED.
6. Once the board is inflated, remove the pump hose by turning it counter clockwise.
7. Replace the cap and lock into place by rotating it clockwise. (image 5197)
B Installing the Fin
1. Loosen the screw to the metal fin clip on the front of the fin. (5207)
2. Slide the metal fin clip into the channel of the fin support and slide the metal clip toward the
front of the board. (5209 and 5211)
3. Remove the screw, leaving the metal clip in the fin channel. (5212)
4. Slide the backend of the fin with pins into the fin channel and slide the fin toward the back of
the board. (5213 and 5214).
5. Align the hole in the front of the fin with the metal clip inserted into the channel from steps 2
and 3. (5213)
6. Reinstall the screw and tighten to secure the fin to the board (5216)
C To Deflate and Store
1. Rinse off the board and bring to a flat clean area, free of any sharp objects.
2. Turn the valve cap counter clockwise to remove the cap.(image 5198)
3. Press down on the spring loaded valve and turn slightly to lock the pin in the open position. Air
will be released from the board.(photo)
4. Starting at the front of the board, fold the board, gently pressing on it to force the air toward
the open valve.
5. Once the air has been evacuated, replace the valve cap.
6. Use the board buckle to keep it in the folded position.
7. Store the board in the provided carrying case/backpack in a dry, moderate temperature (room
temperature, away from extreme heat or cold).