Instructions / Assembly

R 0 5 1 4 9 R E V - A P A G E 1 O F 2
N O T E S
Hardware
See 2nd pg PARTS LIST for
Hardware
Tools
1/4" hex socket bit
Power driver recommended
#2 Phillips bit
Power Entries
Base End Power Entry
No receptacles are displaced when using a base end power entry. Plug
the end of the “whip” assembly into either a power block or harness
jumper attached in a raceway.
A certied electrician must attach the other end of the base power
entry to the building power.
Power Pole – End of Run
Make sure a wedge block is attached to the end of the panel run. Attach
the raceway cover plate to the bottom of the power pole with hardware
provided. Place the cutout in the bottom of the power pole over the
wedge block.
Ceiling Attachment
1) Cut a 2 1/2” x 3 1/2 ” access hole in the ceiling tile directly above the
ceiling power entry outside the footprint attachment point.
2) Cut the pole to size: top of pole should be about 4” above top of
ceiling tile.
3) Push the top of the pole through the access hole in the ceiling tile.
4) Feed the base power entry through the cover and into the opening on
the raceway frame end. Use the septum when running wires inside
the pole.
5) Attach the power entry to the junction block. Match the curved termi-
nal on the power entry to the curved terminal on the junction block.
(See jumpers)
6) Install hanger strip: To gain access to the area, remove a ceiling tile
adjacent to the location of the pole. Twist the hanger strip to lie at
against the pole. Use the provided 1/4-10” bolt, washer, and 1/4” nut
to fasten the hanger strip to the pole. Drill 5/16” clearance holes
through the ceiling grid. Fasten the hanger strip to the ceiling grid with
the provided 1/4-20” bolt and 1/4” nuts. Tighten with a socket wrench.
Insert the provided foam plug into top of the pole.
7) Install the mounting box assembly: Fit the halves of the mounting
bracket together. Insert the provided #10-32 screws into the bracket
holes to hold the halves together. Loosely thread nuts onto screws.
Remove the center knockout from the electrical box (electrical box is
supplied locally). Fit the assembly over the top of the pole. Once
assembly is in position tighten nuts onto screws.
8) Install the trim bezel: Position the trim bezel halves around the pole.
Snap the provided retaining clips through the holes in both trim bezel
the halves. Push trim bezel up against the ceiling tile. Replace the adja-
cent ceiling tile.