Instructions / Assembly

SILVER SHEET
METAL SCREW
(3)
BLACK
MACHINE
SCREW (2)
Trigger on slide
Use furthest slot back
on the outside.
Use middle slot
on the outside.
SILVER
MACHINE
SCREW (8)
FINISHED
DESK
R05163 03/11/11
ASSEMBLY INSTRUCTIONS
Follow Ped to top only - Not Valid for Modesty Panel
Remove the drawers from both pedestals.
Pull each drawer out fully, and move the
slide trigger on each slide up or down to
disengage the inner slide. Then slide
drawer completely out.
Lay the worksurface, bottom-side-up, on a
smooth surface. A carpet is best, but if none
are available, use the carton the top came in.
Be sure to remove all staples from the carton
before using.
See drawing at right. Use the pedestal holes
shown to attach the pedestals to the
worksurface.
Attach pedestals to Worksurface using the (8)
SILVER MACHINE SCREWS into the metal inserts.
Attach the Modesty Panel to the Worksurface using
(3) SILVER SHEET METAL SCREWS into the pre-
drilled holes. Attach the Modesty Panel to the
pedestals at the bottom using a total of (2) BLACK
MACHINE SCREWS.
Turn desk upright. Re-insert drawers,
referring to
the Drawer Instruction Sheet found in the
Pedestals.
The desk may be cleaned with a damp cloth and
gentle cleansers.