User manual

PoStep60 user manual
12
www.poscope.com
4.6 PoStep LEDs
There are five LEDs on the PoStep board showing status.
LED
Status
PWR
LED is on when PoStep is connected to a PC over USB or power supply is connected
VM
LED is on when power supply is connected
STATUS
Indicates various driver states
FAULT
LED is on when driver fault occurred. To see the fault cause the PoStep has to be
connected to a PC and application running
STALL
LED is on when motor stall is detected in hardware.
4.6.1 Status LED
Status LED is used to indicate various PoStep driver states.
Pattern
Status
……….
LED is fast blinking when driver is in firmware update mode.
-.. -..
One long two short blinks indicates default settings are being loaded. Please use PoStep
user application for proper configuration setup and store.
- -
Slow blinks indicate user configuration has been loaded
4.7 Requirements
- One available USB 1.1, USB 2.0, or USB 3.0 port
- USB HID device driver enabled operating system (Windows 98 SE/ME/2000/XP/Vista/7,8,10)
- Included software requires Windows 2000/XP/Vista/7,8,…
- Microsoft Visual C++ 2010 Redistributable Package (x86 or x64) or Microsoft Visual Studio
2010 needs to be installed on the system prior running PoStep60 application.