User manual

PoStep60 user manual
13
www.poscope.com
5 Installation
PoStep60 is USB HID compliant device and as such require no additional drivers for operation.
To operate the device user software installation is necessary on a target system.
6 Technical specifications
6.1 Electrical specification – limiting values
Symbol
Parameter
Min
Max
Unit
V
M
power supply
-0.3
50
V
V
I
input voltage on 10 pin IDC input pins
-0.3
5.8
V
V
ext
supply voltage on pull-up resistor for fault signal
-0.3
50
V
I
oc,max
Fault signal maximum collector current
50
mA
V
DI,MAX
maximum voltage applied to PWM input pins
5.5
V
V
iso
isolation voltage (AC for 1min, R.H. 40-60%)
3000
V
rms
V
esd
electrostatic discharge
-4000
4000
V
I
drv,max
maximum driver output full scale current
6.0
A
6.2 Electrical specification – static characteristic
Symbol
Parameter
Conditions
Min
Typ
Max
Unit
V
I, HIGH
applied voltage for HIGH state on 10 pin IDC
input pins
3.0
5.8
V
V
I, LOW
applied voltage for LOW state on 10 pin IDC
input pins
-0.3
0.4
V
V
DI,HIGH
applied voltage for HIGH state on PWM pins
1.6
V
V
DI,LOW
applied voltage for LOW state on PWM pins
-0.3
0.2
V
NOTE! - The program can’t start because MSVCR100.dll is missing from your computer.
If application fails to start showing above message most likely “Microsoft Visual C++
2010 Redistributable Package” has to be downloaded from MS pages and installed
prior running PoStep60 application.
NOTE! - The application was unable to start correctly (0xc000007b). Click OK to close the
application.
If application fails to start showing 0xc000007b error please install “Microsoft Visual
C++ 2010 Redistributable Package (x86)” no matter you have 64-bit MS Windows
operating system running.