User manual

PoStep60 user manual
24
www.poscope.com
7.8 Firmware update
Application automatically checks for PoStep60 driver firmware version and advises when update
needed. If by any chance automatic firmware update fails a manual update is possible. Please select
“Firmware” tab and manually reset PoStep60driver to enter boot mode ie. when “Full update”
button is enabled. Trigger update by pressing “Full update” and wait for finished update. After
update the driver automatically resets and enters normal mode.
Figure 17: Manual firmware update
1. Restart driver manually – trigger driver restart and enables the driver to enter boot mode.
2. Full update – trigger start of full firmware update
3. Update progress bar – shows status of update progress.
7.9 Major changes in application version 0.61
 Added Auto run mode
 Position control navigation tab changed to Auto control
 Auto control tab restructuring
7.9.1 Major changes from 0.57 to 0.58:
 Voltage Too Low when disabled bug fix
 BINx mode - Button Up/Down control added
 I2C communication added
7.9.2 Major changes from 0.53 to 0.57:
 Predriver Fault bug fix
 Position control added
 DC motor mode setting added
 DC motor control added
 Improved Voltage and Temperature filtering
 Added installation notes (MS VS 2010 redistributable package)
1: Restart driver manually
2: Trigger manual update
3: Update progress bar