Instructions / Assembly

METAL FRAME
Overshelf
Channel at
top of FRAME
Flange on
Overshelf
In the hardware bag, locate the two BLACK
SCREWS. Line the hole in the FRAME with
the hole in the side of the Overshelf. Screw
the BLACK SCREWS into the sides- one on
each side.
TACKBOARD
TACKBOARD
Take the TACKBOARD, and
slide it up under the upper
flange of the FRAME. Press it
into the FRAME, and slide it
down into the lower flange of the
FRAME, as shown.
Slide up
Press in
Slide down
PARTS LIST
QTY DESCRIPTION PART #
(1) TACKBOARD (IN FRAME) 48"- 700107
60"- 700108
72"- 700109
(1) METAL FRAME 48"- MG772888
60"- MG772889
72"- MG772890
HARDWARE BAG:
(2) BLACK SCREW (#10-24 X 1/2) F09542
Your Tackboard is ready for use.
R05106 12/06/06
TACKBOARD ASSEMBLY
Remove the TACKBOARD from the
metal FRAME. Set the TACKBOARD
aside.
Align the metal FRAME with the
Overshelf as shown. The channel at the
top of the FRAME will go over the rear
flange of the Overshelf, as shown in the
Detail.
Before assembly, make sure that you
have everything you need- check your
parts against the parts list at the bottom
of the page. If you are missing anything,
please call us at 1-800-621-8846.