Instructions / Assembly

ManualsBrandsUnbranded ManualsOutdoors5-Piece Wicker Outdoor Dining Table Set Patio Dining Table and Chairs, Round Tempered Glass Tabletop with Grey Cushions

Cannes KD Carver Chair incl.

cushion





1 / 6



Assembly Instructions

Product size:

W59*D61*H90.5 cm

Furniture should be covered/stored whilst not in use to prolong its longevity.

(It should also be covered in adverse weather.)

This product is for Domestic use only!

IMPORTANT, RETAIN FOR FUTURE REFERENCE

READ CAREFULLY

Summary of content (6 pages)

PAGE 1
Cannes KD Carver Chair incl. cushion Assembly Instructions Product size: W59*D61*H90.5 cm Furniture should be covered/stored whilst not in use to prolong its longevity. (It should also be covered in adverse weather.
PAGE 2
Cannes KD Carver Chair incl. cushion Before you start wipe with a clean, dry cloth. Warnings Don’ts IMPORTANT, RETAIN FOR FUTURE REFERENCE READ CAREFULLY Never tilt the chair during use. See enclosed instructions for assembly, safety and care information. Do not stand or climb onto the product. Failure to follow the warnings could result in serious injury. Do not use power tools to construct this product. Handle heavy parts with care. Do not sit or lean onto the rims of this product.
PAGE 3
Cannes KD Carver Chair incl. cushion Components, fixtures & fittings (not actual size) Parts List Part No. Diagram A Qty Part No. 2 PCS B Backrest C 2 PCS D Left Armrest/Leg 2 PCS Right Armrest/Leg 2 PCS F 2 PCS Cushion Seat Panel F1 Qty Front Leg 2 PCS E Diagram 1 PC F2 12 PCS Spanner Bolt Head Cap F3 12 PCS F63 Washer 12 PCS M6*20mm Bolt Please note the diagram is for reference only, it may not fully represent the actual appearance of the parts.
PAGE 4
Cannes KD Carver Chair incl. cushion Step by step assembly instructions Step One Align Backrest (A) with Right Armrest/Leg (D). Carefully insert the tubular mating part of Right Armrest/Leg (D) into the end of the tube on Backrest (A). Connect the Backrest (A) and Right Armrest/Leg (D) using Washers (F3) and Bolts (F63). Make sure all bolts are in place and turn freely. At this stage, don’t tighten the bolts. Step Two Repeat above steps for Left Armrest/Leg (C) as shown.
PAGE 5
Cannes KD Carver Chair incl. cushion Step Four Turn the partly-assembled chair upside down. Locate assembly holes, connect all parts using Washers (F3) and Bolts (F63). Make sure all bolts are in place and turn freely. At this stage, don’t tighten the bolts. Step Five Turn the partly-assembled chair to the upright position. Push Seat Panel (E) into place as shown. Step Six Turn over the partly-assembled chair. Fix the Seat Panel (E) in place using Washers (F3) and Bolts (F63).
PAGE 6
Cannes KD Carver Chair incl. cushion Step Seven Level the chair with pre-fitted adjustable foot. Adjustable Foot Step Eight Place the Seat Cushion (F) onto the Seat Panel (E). Your chair is now ready for use. Never tilt the Chair during use. Ensure the product is always placed firmly on the ground.