User manual

UDOO Starting manual (beta) Version 0.3
http://www.udoo.org/
26"
Hit any key to stop autoboot: 1
3. Before the counter reaches 0, press any key on the external PC’ s serial console.
i.Mx6Q_UDOO_BOOT> _
4. Close the serial monitor and unplug J18 jumper. This will allow the communication
with the programming port of SAM3X8E;
5. Plug the jumper J22 for 1 second, then remove it (to erase the old sketch
programmed in SAM3X8E);
6. Plug the jumper J16 for 1 second, thend remove it (to reset the SAM3X8E);
7. Select from the IDE: Tools –> Board –> Arduino DUE programming port and select
the correct serial COM from the IDE;
8. Send the sketch using the IDE upload button.
9. Press the reset button to restart i.MX6 and use Ubuntu or Android again.