User manual

UDOO Starting manual (beta) Version 0.3
http://www.udoo.org/
43"
Configuration
Now it is necessary to configure properly the serial port in order to match i.Mx6
debug serial port.
Open “Setup” menu and select “Setup port…”
In the following picture are shown the correct parameters needed to talk with i.MX6
Debug Serial Port.
Press “OK”.
Usage
Plug the USB cable to CN6 on UDOO and to an USB port of the host PC. The chip is
powered by the USB cable, so it will be shown a serial port connected to the PC
Please be aware that if UDOO main power plug is not connected, then USB power
supply is insufficient to let UDOO run.
Open File menu, select “New connection…” (Alt+N) and choose the correct serial port.