Use and Care Manual
16
Now the second gable in the foot is to connect with the oor lengthwise prole in the same way already
known. Push the grooved prole and ridge prole into the nuts / slots of the gable proles. Screw down
as well with the grooved and ridge end plates.
Now a small angle 30/30/20 x 2 can be screwed in by means of sheet metal screws 4,2 x 16 to secure
the oor proles (see step 15). If you use a foundation frame this angle not urgently necessary, as the
foundation frame has an L-connection (see p. 13).
Now the skeletal structure is nished – topping-out ceremony is the order of the day!
Please open now the accessories box. Here you nd:
1 pc skylight including automatic window opener contents see p. 8
1 pc divided revolving door contents see p. 9 + 10
1 pc back wall window contents see p. 11
These parts are to mount according to the instructions (see p. 8 – 11).
Doors and back wall window can be mounted at both gables. Borings for the door hinges / bands exist
in every proles of frames of doors. However, please take care that we have intended the borings for
the door locking device at only one verge ashing prole (see step 5). Should you mount the door on
the other side, the corresponding borings have to be transferred then.
The skylight is to push from the lateral into the ridge (see step 16). This system is generally very
simple and explains itself.
Further useful notes:
Erection with a foundation frame:
This is the simplest but also the securest erection of a greenhouse. The foundation frame is hooked
non-positively into the oor prole of the greenhouse and screwed down in the edges by an angle
bracket (see p. 13).
It is best and easiest to assemble the foundation frame together with the greenhouse! But this is
also possible later – without any energy. Then you only must lift the greenhouse (it is best to do this at
one side) and laterally hook in the foundation frame into the oor prole.
Erection with the foundation frame:
At rst you have to dig a small ditch, cut of the spade approx. 10 – 12 cm deep, according to the
given measurements of the foundation frame. In each of the four corners you horizontally place a
cobblestone as a support for an exact level compensation. This avoids a possible sinking of the
greenhouse. Then the greenhouse with the foundation frame is to put in this ditch and the foundation
frame is to ll by the excavated material. It is useful to lay down there some garden plates or
agstones in order to avoid any dirty splashes at the greenhouse due to strong rain. Besides, working
around the greenhouse is simpler, e.g. mowing the lawn.