Use and Care Manual
2
SPECIFICATIONS
SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
product before using. The owner and operator of this equipment shall have an understanding of this product and
safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of
this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the
operator's native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of
this product, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any equipment that
appears damaged in any way, or operates abnormally shall be removed from service immediately. If the product
has been or suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it),
immediately discontinue use until the equipment has been checked by a factory authorized service center (contact
distributor or manufacturer for list of authorized service centers). It is recommended that an annual inspection be
done by qualiîżed personnel. Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
The Toilet Master Jack is designed to lift, and temporarily support, rated capacity loads consisting of one, standard-
sized toilet.
Model Capacity
Base Size
(L x W)
Min. Height Max. Height Volume Hyd. Oil
Net
Weight
RT100 175 lbs. 24" x 14-3/8" 6-1/2" 25-7/8" 85 mL 22.05 lbs.
ASSEMBLY
1. Tools required: 16mm wrench, 5mm Allen wrench,
needle nose pliers.
2. After locating and inventorying all components, it
may be more convenient to service the Bottle Jack
before attaching it to the Base Frame. Refer to
Steps 4 and 5 under PREPARATION.
3. Place Bottle Jack on Base Frame pedestal and
thread Attachment Pin through Bottle Jack Frame
tabs and hole in Bottle Jack ram. Using two socket
head cap screws, assemble Bottle Jack to Base
Frame (reference Fig. 1).
Figure 1 - Bottle Jack assembly
Attachment Pin
(not shown)
Socket Head
Cap Screws
Ram
Tabs