Use and Care Manual

PREPARATION

Verify that this product and your application are compatible, if in doubt contact Customer Service 337-962-6878.

2. Before using this product, read this operator's manual completely and familiarize yourself thoroughly with the

product and its components, and recognize the possible hazards associated with its use.

3. To familiarize yourself with basic operation, locate the

bottle jack release valve knob and turn it:

a. Clockwise until rm resistance is felt to further

turning. This is the ‘CLOSED’ release valve position

used to raise the Toilet Master lifting arms.

b. Counter-clockwise, but no more than 1/2 turn from

the closed position. This is the ‘OPEN’ release valve

position used to lower the Toilet Master lifting arms.

4. With ram plunger fully retracted, locate and remove

the oil ller plug. Insert the handle into the handle

sleeve, then pump 6 to 8 strokes. This will help release

any pressurized air, which may be trapped within the

reservoir. Ensure the oil level is just below the oil ller

hole. Reinstall the oil ller plug.

5. Check that the pump operates smoothly and easily

before putting into service. Replace worn or damaged

parts and assemblies with authorized replacement

parts only.

6. Assemble bottle jack to lift pedestal using supplied

socket head cap screws.

Spring

attachment

points

Release Valve Knob

Oil Filler Plug

(not shown)

Pump Handle

5. Assemble the front and rear Casters to the Base

Frame using an acorn nut, one washer and one lock

washer per caster (reference Fig. 3).

4. Attach one end of Return Spring to bolt on Bottle

Jack base and other end to Attachment Pin

(reference Fig. 2).

Figure 2 - Spring attachment

Figure 3 - Caster assembly