Use and Care Manual

5
OPERATION
Removing Wall Mounted Toilets:
1. Close water supply valve and ush toilet.
2. Disconnect water supply line.
3. Remove left and right side bolt nuts and washers.
4. Carefully position the Toilet Master Jack around toilet.
5. Close Bottle Jack Release Valve by turning knob clockwise.
Do not over-tighten or over-loosen release valve knob. Do not use mechanical means to force release
valve knob. If valve becomes stripped or otherwise operates abnormally, discontinue use of the Toilet
Master Jack until repair service can be performed.
6. Insert Bottle Jack Handle into Handle Sleeve and pump until the Toilet Master Jack arms contact lift point. Back
toilet away from wall until toilet clears bolts.
7. Roll the Toilet Master Jack and toilet to desired position.
Always lower toilet slowly. Open release valve carefully. Do not drop toilet to oor.
Replacing Wall Mounted Toilets:
Exersize caution when lowering the jack and toilet. Control the rate of descent with the release valve knob at
all times. The more you open the release valve, the faster the load will descend. Do not allow toilet to drop.
1. With new seal in place, roll the Toilet Master Jack and toilet into position on mounting bolts.
2. Install washers and nuts hand tight.
3. Lower the Toilet Master Jack and roll out of way.
4. Tighten nuts to secure seal and toilet to wall.
5. Connect water supply line and open valve.
4. Store the Toilet Master Jack with arms fully lowered to reduce exposure of bottle jack ram to rust and contamination.
!
!
!