o neocolonialism HOW TO INSTALL YOUR BARN DOOR BARN DOOR RAIL SYSTEM IMPORTANT PLEASE READ ALL INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION. * These instructions are for a single door installation. * identify secure points on the wall to attach the rail before starting your installation. ¢ list necessary that all the lag screws used to install the rail are secured to the wall stud (2 x 3 structure). * Use a wood plank secured to the wall stud if you are unable to fix all lag screws in wall stud.
. o AN Drill 732" pilot holes at each mark. Place one lag craw through the middle hole #1 through a spacer. Do not fully tighten. Repeat process with holes #2 and #3. Use a love on top of the rail to ensure it is properly felled, then tighten the 3 lag screws. NOTE Lag screws #4 and #5 will be installed later.
. Complete your Installation NOTE Anti-jump bumpers must bs installed Hang the door on the rail, ensure the door is Turn anti-jump bumpers so they are on top to prevent door from derailing. Leveled then, fix the door guides on the floor of the door and underneath the rail on on the opening side. as lose to the Tighten the screws. Loosely fasten the anti-jump bumpers 2° from each door hanger. To be able to instant the door on rail.
COMMENT INSTALLER VOTRE PORTE DE GRANGE SYSTÈME DE PORTE MURALE IMPORTANT VEUILLEZ LIRE LES INSTRUCTIONS AVANT DE COMMENCER L’INSTALLATION. * |l s'agit d'instructions pour installation d’une porte simple. « Avant de débuter, déterminer I'emplacement des trous de faon a assurer un ancrage solide au mur.
Nl AN Pré-percer cague m’argue & U'aide d'une miche de 7/32". Placer un espaceur mériédrie le trou #1 ety insérer un tire-fond. Ne pas serrer complètement. Répéter le processus pour les trais 12 et 3. Utiliser un niveau au-dessus du rail pour s'assurer qu'il est de niveau, puis serrer complètement les 3 tire-fonds. NOTE Les tire-fonds #4 et #5 seront installés plus tard, 2. Installation des roulettes inséra las boulons avec les rondelles dans |a porte et fixer la roulette cava fes rondelles et les écrous.
Mise en place NOTE Les rondelles anti-déraillement doivent être installées pour empocher Ia porte de dérailler. Sans semer, tiser les rondelles anti-ministérielle & une distance de 2 de chaque roulettes. Pour pouvoir installée |2 porte sur le rail, les rondelles Monter la parte sur fe rail, en &"assurant qu'elle est de niveau, pulls tiser les guides de porte au sol. le plus prés possible de l'ouverture. NOTE pour guides de porte deux types de guide tans fournies. Fertiliser selon votre type de porte.