Installation Guide

ManualsBrandsUnbranded ManualsHeating7-Day Wi-Fi Smart Thermostat for Remington Solar Attic Fans

How to Install the Remington Solar Smart Wi-Fi Thermostat / Humidistat

Each fan has the thermostat/humidistat device to the left.

You will replace it with the following devices:

Fig. A Fig. B

Fig. A is the replacement thermostat/humidistat. Simply unplug the old thermostat at the plug end of

the wire, and plug in the new thermostat. You may attach the white box to a stud or frame in your attic.

Make sure the antenna is connected.

Fig. B is the Wi-Fi hub components. They will connect as follows:

This is a Wi-Fi hub. It

will connect to the

router you use at home

for all your household

Internet connections.

Simply plug it in to one

of the router ports on

the back. It will also

need power, so plug it

into a 110V power

source using the plug

provided.

Summary of content (6 pages)

PAGE 1
How to Install the Remington Solar Smart Wi-Fi Thermostat / Humidistat Each fan has the thermostat/humidistat device to the left. You will replace it with the following devices: Fig. A Fig. B Fig. A is the replacement thermostat/humidistat. Simply unplug the old thermostat at the plug end of the wire, and plug in the new thermostat. You may attach the white box to a stud or frame in your attic. Make sure the antenna is connected. Fig. B is the Wi-Fi hub components.
PAGE 2
Now you need the app to drive it all and make it work. (Note: all this looks a little complicated, but we just want to take you step-by-step. Don’t worry, it’s simple…and totally worth it.) To set up the network. Start with connecting the Hub to your internet router using the provided cable and power. When it is propertly connected, power indicator light and internet connection light should stay steady bright blue.
PAGE 3
Download the APP on your smartphone from either iTune, or Google. Search for “SolaCom” After you download the app, the first time you open it, “register” your account first. To register, you will need to enter your email address and then click “Sent”. You will get an authentication code sent to the email you put in.
PAGE 4
PAGE 5
Set your password and “Confirm”. You will see this screen. Click “OK” to activate the QR scanner in the app. This the next screen you will see, click “Add device”, a scanner view window will open, scan the QR code on the back of your hub.
PAGE 6
You can add the hub by either scan the QR code, or, select “New GPRS Hub” then type in the serial number below QR code. Now you need to pair the Hub to the controller. Once the Hub is added, a new window will let you add a device, select “scan QR code or barcode” to scan in the QR code on the controller, which is located on the side of the thermostat. Your app should now show the Smart Thermostat icon. From there you can adjust your temperature and humidity settings as well as turn the fan on or off.