Instructions / Assembly

Inspect your stilts prior to every use. Check for worn or

damaged parts and replace with genuine SUR-STILT parts.

Tighten but do not overtighten any loose nuts, wing bolts, or

screws.

If you have any comments or questions concerning your

stilts, please contact our Customer Service staff.

INSPECTING YOUR STILTS

QUESTIONS? NEED HELP?

Toll free : 1-888-443-8889

Check your stilts for wear and damage. Check and tighten

all nuts and bolts.

Cover any openings such as windows, stairwells or vents.

Do not over-extend your step or your reach while working

and walking on stilts.

Lubricate your stilts with silicone or graphite based

lubricants.

Clean with water. Dry stilts and floor plates after cleaning.

Load limit is 225 lbs. including working tools.

GENERAL PRECAUTION

ASSEMBLY

1) Assemble side pole clamps. Insert

lower side poles through the bottom of

the tube clamps.

2) Attach lower side poles to the safety-

lock bracket connection with the

attached ¼” x 1 ½" cap screw & nylon

lock nut.

3) Install upper side poles through the

side pole clamps. Position so the leg

bands comfortably fit above your leg

calf.

4) Position the side pole clamps in the

clamp bracket slots, according to your

calf height and position. Tighten all

nuts and bolts on side pole and clamp

assemblies.

5) Attach the heel brackets to the foot

plates using the No. 10 x ½” philips

machine screws and nuts. Adjust the

heel bracket so your foot fits

comfortably on the nylon foot plate.

Tighten well.

READ THE CAUTION LABEL ON THE STILT

SIDE POLE AND HEEL BRACKETS

STOP! DO NOT RETURN THIS PRODUCT TO THE RETAILER.

Questions? Problems? Contact Manufacture Directly 1-888-443-8889