Instructions / Assembly

STRAP ADJUSTMENT
LUBRICATION
Keep all pivot points and adjustment joints clean and
lubricated. Lubricate lightly when necessary with a
silicone or graphite based lubricants. Use water only for
clean-up of stilts. Keep floor plates clean and free of
lubricants or any debris which could cause slippage.
MAINTENANCE
Contact your dealer or customer service for parts.
®
Always use genuine SUR-STILT parts to repair or
replace worn or damaged parts.
GENERAL REPAIR AND
REPLACEMENT PARTS
To access nylon sleeves, disassemble the upper foot
plate. Remove the small sleeves from the extension
tubes. The large sleeves can now be removed and
replaced.
REPLACEMENT OF NYLON SLEEVES
1. Remove screws and washers.
2. Feed the ends of both straps through the Safety
Anchor Slot System™.
3. Tighten screw and washer assembly.
STRAP ADJUSTMENT
HEIGHT ADJUSTMENT
1. Remove wingbolts.
2. Raise each stilt to the necessary height.
3. Install each wingbolt through the leg extrusions.
4. Tighten the wingbolt and fully engaging the nut.
SPRING TENSION ADJUSTMENT
1.Increase tension on upper spring if you lean too far forward.
2.Increase tension on lower spring if you lean too far backward.
6
3
ARCH AND TOE STRAPS ARE PREINSTALLED
If adjustment or replacement is necessary
STOP! DO NOT RETURN THIS PRODUCT TO THE RETAILER.
Questions? Problems? Contact Manufacture Directly 1-888-443-8889