Replacement Part List

Attention

1. Read this manual carefully before using this system.

2. Avoid using the device in extremely cold, heat, or humidity environment, it

may damage the device.

3. Do not drop or press hard on the device.

4. Warranty invalidation if the device is disconnected by users or has any

physical damages.

5. Always back up your date before connecting your SD device to this system.

The manufacturer is not responsible for any date damage on your device for

any reason.

6. Do not disconnect the unit while recording or playing. It may damage the unit

and/or the SD device.

Application

With camera for pipe diameter form Φ 45mm to 600mm

1. Water supply

2. Waste water

3. Electrical air conditioner

4. Cable ducting

5. Ducted vaccum systems

6. Plumbing

7. In buliding

Camera

1. Stainless steel hoursing

2. Lens

3. White LED light(8 pcs)

Cable wheel

1. Counter box

2. Reset button

3. Metric&Imperial button

4. Female plug

5. Cable Reel

6. Bracket

Fuse

1. The fuse and fuse cap on control box are not assembled during shipping,

please relocate the fuse with cap to the fuse holder before use.

2. If the status LEDs on the control box don’t light up after switching on the

control box, check the fuse.

• Turn the fuse cap counter clockwise to remove it from the control box.

• Only replace the fuse with a new one with the same specifications as the

original one (F2A250V).

Charge the battery

1) If the status LEDs on the control box in lower level, charge the battery

Insert the charge adaptor cord into the battery charge jack.( Figure )

2) Switch to the charge position on control box.

3) Charge LED will be red during charging and turn green when finish charging

(normally charging time 6-7 hours).

Figure