Replacement Part List

CONTROL BOX
24
1. Switch（CHARGE,OFF,AV,DVR） 2. LED bright adjust knob
3. Video output jack 4. Battery level indicator
5. DVR up selector button 6. DVR left selector button
7. DVR menu selector button 8. DVR down selector button
9. DVR right selector button 10. To camera cable jack
11. DVR record/stop/play button 12. DVR file display button
13. DVR stop/back button 14. DVR playback button
15. Charge adaptor jack 16. USB keyboard jack
17. SD card socket 18. Earphone jack
19. Fuse socket 20. Microphone switch (on/off)
21. Microphone window 22. DVR status
23.BATT./DC12V 24. Remote controler receiver
PLEASE NOTE: WHEN THE BATTERY LEVEL INDICATOR FLASH THAT THE POWER WILL
CUT OUT 90 SECONDS LATER YOU SHOULD SAVE THE RECORDING DATA AND
CHARGE THE BATTERY ASAP OTHERWISE YOU WILL LOST THE IMAGES YOU ARE
RECORDING!
4
Time stamp setting
Basic operation
1. IMPORTANT: When connecting the camera to the Monitor the power must be off.
2. Screw the camera to the reel cable and connect the reel to the Monitor. Make sure the
camera lens is clean.
3. Press the switch on the monitor and DVR will work after five seconds.
Gently insert the camera into a pipe duct, etc and reel out the cable until it is at the desired
depth.
IMPORTANT: Avoid kinking the fiberglass cable as this will cause irreversible damage. Do not
bend under sharp angles and do not twist the cable.
NEVER use the camera and/or cable as an unclogging tool.
4. Adjust the LED bright knob to suitable position.
5. Press the MENU button to enter the setup of the monitor. Move through the setup
page .Using the select button and adjust the values with the UP and DOWN buttons.
Press and hold the UP and DOWN buttons to increase setting speed. Following values
can be set between 0 and 100: bright-contrast- color –language-16:9 - 4:3-sleep)
6. To view the images on another screen (not incl.) connect that screen with a video cable (not
incl.) to the VIDEO OUTPUT on the control box.
7. After use, switch the power off, carefully retract the camera from the inspection area. Clean
the cable and wind it back on the reel. Disconnect all cables and place the protective caps
back on the connectors. Make sure the camera and cables are clean and dry before storing
them back in the case. Use a clean, soft and dry cloth to clean it .
8. Storage and cleaning
• Always return the equipment back to its protective case when not in use.
17
System Setting
Format
Card info
Time stamp
Time
Language
No
Yes
Date Format
LED BRIGHT
DVR POWER
MIN. MAX.
CAMERA
BATTERY
INDICATOR
OUT
MIC
VIDEO
off
MIC
on
REM
REC STATUS
SD
P LAY
PAUSE
STOP
ESC
MENU
OK / REC
REPLAY
Memory Card
USB
KEYBOARD
EARPHONE FUSE
Batt./EXT
DC 12 V
CHARGE
DC 12 V