Replacement Part List

At the job site
Before staring any locating job, please follow these simple steps. An ounce of
preparation here can prevent ton of embarrassment and lost time.
Survey the area –before turning on any transmitter turn your receiver on, flip
the switch to “Far”, and turn the sensitivity all the way up .Walk around the
area where you will be locating and check for source of noise or electrical
sources can all cause the receiver to respond as though there is transmitter in
the area .mark any of these “hot spots”Aa so you won’t be fooled by them
when you’re locating.
Test your equipment
Put the battery our transmitter [or turn it on] and throw in on the ground, then
turn on the receiver and turn up the sensitivity .be sure you are getting full
range out of your equipment .you should be able to walk 12feet away from a
flushable transmitter ,15 feet from a -10 transmitter or 25 feet away from a 20
transmitter and get a signal on the meter (at maximum sensitivity ). Anything
less than this requires fresh batteries and another run through this test .if this
doesn’t solve it, there may be a problem with the transmitter or receiver (see
the Troubleshooting section).
You’ll be glad you took the time!
9