Replacement Part List

The ROD contains the antenna that picks up the signal from the camera with

512hz transmitter. It also points you in the direction of the line. Never use the

rod as a probe or leveer-it will break the ferrite core and reduce the receiver’s

sensitivity considerably.

〝

X marks the spot! When you have found a peak or null, it’s right below

the center of the rod.

〞

The SENITIVITY knob allows you to control the amount of signal you see on

the meter and hear through the speaker. It is also the on/off switch.

The METER indicates the strength of the peak signal(to the right) and the null

signal (to the left).

The NEAR/FAR switch controls overall sensitivity. The

〝

Far

〞

position is

the most sensitive, useful for beginning a locate. As you close in on the

transmitter and the meter goes to full scale and you can’t reduce the sensitivity

any further, switch to

〝

Near

〞

to pinpoint its precise location.

The PHONE JACK accepts standard stereo headphones.

The SPEAKER allows you to hear the transmitter’s signal-beeping or

continuous, depending on the transmitter used.

The BATTERY compartment holds 6

〝

〞

alkaline cells. Rechargeable

batteries will not perform as well, nor last as long. Cheap carbon-zinc batteries

can leak and damage the inside of your receiver.