Use and Care Manual

TEST OPERATION

1 Adjust the air pressure at 5 bar (70 p.s.i.) and connect the

air supply.

2 Without touching the trigger, depress the staple discharge

outlet against the work-piece.

Pull the trigger. (The tool must fire the fastener.)

3 Adjust the air pressure as much as the lowest possible ac-

cording the length of fastener and the hardness of work-

piece.

AIR HOSE CONNECTION

Connect the air chuck to the air plug.

When connecting the air chuck, do not point the staple dis-

charge outlet at any part of your body or at another preson,

and do not touch the trigger.

DRIVING FASTENERS

1 Depress the staple discharge outlet against a place where

you want to drive a staple.

2 Pull the trigger.

CLEARING JAMMED STAPLES

1 Disconnect the air hose.

2 Remove the set of staples from the magazine.

3 Take out the 4 hexagon socket head cap screws from the

magazine and remove the driver guide.

4 Clear the staples jammed inside the nose using a thin iron

bar or a flat-blade screwdriver.

5 Reinstall the driver guide cover, reinsert the set of staples

and bring back the slider unit.

ALWAYS disconnect air supply before clearing jammed fas-

tener.

WARNING

Trigger

Outlet

Driver

Guide

Flat-blade

screwdriver

Slider Unit

WARNING