Installation Guide

2. Place the soaked TreeDiaper
®
product
darker side up on top soil and around plant
base in the container.
3. The plant will stay watered for 2-5
weeks. When there is less than 1/4 of the
initial water, begin again at step 1.
1. Place the TreeDiaper
®
product
completely submerged in water in a sink
or bucket for at least 5 hours or overnight.
Using TreeDiaper product on
indoor plants
A)
2. Place the soaked TreeDiaper
®
product
around plant base in the container with
darker side facing up.
3. The TreeDiaper
®
product can be
recharged by rain or irrigation, but should
be checked weekly. When there is less than
1/4 of the initial water, water the plants
normally as needed, or begin again at step 1.
Using TreeDiaper product on
outdoor plants
B)
or
Thank you for purchasing
TREEDIAPER
®
For best results, please follow
these procedures to install and use
your TreeDiaper
®
product!
TREEDIAPER
®
Advanced Plant Hydration System
INSTRUCTIONS
For Container Plants
NOTE:
• Covering with mulch, pine needles, or leaves is recommended.
•
tomato cage on top of TreeDiaper
®
fo ssol eht ni tluser yam sihT .stcudorp
functionalities of TreeDiaper
®
products.
• Direct contact of fertilizers with the material in use or in storage may
temporarily or permanently affect the performance of the product.
• Do not poke TreeDiaper
®
ecafrus eht ot egamaD .skcits htiw stcudorp
integrity of the TreeDiaper
®
products may decrease functionality of the
product.
If you have any questions, please email [e-mail].
Version 2.0.17. Updated on 9/25/2017
1. Place the TreeDiaper
®
product
completely submerged in water in a sink
or bucket for at least 5 hours or overnight.
• Always place the mat with the darker black woven side facing up!
®
®