Instructions / Assembly

Light
switch
Lever
TM
Scary Lights & Sounds!
15
+
Batteries Included
(for demo purposes only)
Controls YOUR light switch!
Works with most standard light switches.
SURFACE WASHABLE ONLY.
ALL NEW MATERIALS:
PLASTIC, METAL
Item #58481
LIGHT SWITCH LEVER™
is a trademark of Tekky.
Copyright © 2018 Tekky.
All Rights Reserved.
MADE IN CHINA
Manufactured for and distributed by:
Tekky, Orland Park, IL 60467 USA
TekkyDesign.com
RECOMMENDED INSTALLATION
ALWAYS TURN OFF POWER ON THE ELECTRICAL
CIRCUIT BREAKER TO YOUR SWITCH WHILE
PERFORMING SETUP.
1. Carefully remove and discard packaging.
2. Insert 3 brand new “AAA” alkaline batteries into the
battery compartment located on the back of the
Light Switch Lever™.
3. Using a screwdriver, remove the two screws securing
your existing light switch plate. (DO NOT REMOVE
PLATE.) Line up the cover placing it over the light
switch with the handle in the down position. (See
Illustration A)
* NOTE: If the Light Switch Lever™ does not fit
securely over the plate, proceed to OPTIONAL
INSTALLATION instructions (below).
4. Line up the exposed hole. Insert the screw in the top
hole and tighten the screw securing the cover over the
plate. (See illustration B)
5. Move the handle of the Light Switch Lever™ into the
up position — exposing the bottom hole —and insert
your existing screw. Tighten the screw securing the
Light Switch Lever™ to your light switch plate.
(See Illustration C)
6. Turn power on electrical circuit breaker back on.
7. Flip the handle to operate the lights in your room and
enjoy scary lights and sounds!
OPTIONAL INSTALLATION
ALWAYS TURN OFF POWER ON THE ELECTRICAL
CIRCUIT BREAKER TO YOUR SWITCH WHILE
PERFORMING SETUP.
1. Using a screwdriver, remove the two screws securing
your existing light switch plate. Set your existing plate
aside exposing the switch.
2. Place the Light Switch Lever™ over your light switch
with the handle in the down position. Line up and
insert the switch into the back cover. (See Illustration A)
3. Insert and tighten the screw in the exposed top hole
securing the cover over the switch. (See Illustration B)
4. Move the handle of the Light Switch Lever™ into the
up position exposing the bottom hole. Insert and
tighten the screw securing the Light Switch Lever™ to
the wall. (See Illustration C)
5. Turn power on electrical circuit breaker back on.
6. Flip the handle to operate the lights in your room and
enjoy scary lights and sounds!
BATTERY INSTRUCTIONS
AND CAUTIONS
• Battery installation and removal should be
performed by an adult.
• Remove batteries when not in use.
• Use only batteries recommended in the
instructions.
• Do not mix new and used batteries.
• Do not mix alkaline, carbon-zinc,
nickel-cadmium, rechargeable or different
types of batteries.
• Be mindful to insert batteries with the
correct polarity (+/-) as indicated.
• Remove all exhausted batteries.
• Rechargeable batteries are only to be
charged under adult supervision.
• Rechargeable batteries are to be removed
from the item before being charged.
• Non-rechargeable batteries are not to be
recharged.
• The supply terminals are not to be
short-circuited.
• Always dispose of exhausted batteries
properly.
• Do NOT dispose of batteries in fire, they
may leak or explode.
A B C
***IMPORTANT***
Always turn off power on
the electrical circuit
breaker to your switch
while performing setup
outlined below! DANGER!
Electric shock could
result if power is not shut
off during installation.
Also, make sure to
thoroughly test the item
with your switch to
ensure it is functioning
well and safely. If item
does not function well or
properly, do not use this
item with your switch.
SAFETY FIRST!