CONTENTS Item Description Qty A Table Top 1 B 1 D Panel-1 Panel-2 Panel-3 1 E Panel-4 1 F G Tank Seat M6x16 screw Wrench 1 1 Washer Battery Lava Rocks 17 1 1 Box C H I J K 1 17 Page 1
Assembly 1. Join the panels (B,C) onto the table top (A) using 8pcs M6x16 screw (G) and washer(I). 2. Join the panels (D) onto the table top using 5pcs M6x16 screw (G) washer(I). 3. Join the panels (E) onto the table top using 4pcs M6x16 screw (G) washer(I). 4. Join the tank seat (F) onto the body using 4pcs M6x16 screw (G) washer(I).
5. Check that the control knob for the gas supply system is turned to the “OFF” position before starting any assembly. 6. Remove door from body and place propane gas tank (not included) into the metal stand inside of the body . 7. Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the body to the cylinder valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten connections by hand only.
before starting any assembly. 8. Once the tank is attached to the regulator, make sure the propane gas tank sits on the metal stand inside body completely. Turn the preassembled wing screw on the outer part of metal stand clockwise to secure the propane gas tank tightly. Replace the door onto the body. 9. Remove the rubber cap on the electronic igniter (L) by unscrewing and slide battery into the battery slot. Make sure the positive side of the battery faces outwards.
