Instructions / Assembly

ManualsBrandsUnbranded ManualsKitchenWhole Home UV Water Treatment System 12 GPM

Section 1 Safety Information

These are the original instructions. Please read this entire manual before operating this equipment. Pay attention to all

danger, warning, and caution statements in this manual. Failure to do so could result in serious personal injury or damage to

the equipment.

Make sure that the protection provided by this equipment is not impaired. DO NOT use or install this equipment in any

manner other than that specified in the installation manual.

1.1 Potential Hazards:

Read all labels and tags attached to the system. Personal injury or damage to the system could occur if not observed.

1.2 Safety Precautions:

Waste electrical and electronic equipment (WEEE). This symbol

indicates that you should not discard wasted electrical or electronic

equipment (WEEE) in the trash. For proper disposal, contact your

local recycling/reuse or hazardous waste center.

This symbol indicates not to store any combustible or flammable

material close to the system.

This symbol indicates there is Mercury present.

This symbol indicates that the contents of the transport package are

fragile and the package should be handled with care.

This is the safety alert symbol. Obey all safety messages that follow

this symbol to avoid potential injury. When on the equipment, refer to

the Operational and Maintenance manual for additional safety

information.

This symbol indicates safety glasses with side protection is required

for protection against UV exposure.

This symbol indicates a risk of electrical shock and/or electrocution

exists.

This symbol indicates gloves must be worn.

This symbol indicates the marked equipment may contain a

component that can eject forcibly. Obey all procedures to safely

depressurize.

This symbol indicates safety boots must be worn.

This symbol indicates the system is under pressure.

This symbol indicates the operator must read all available

documentation to perform required procedures.

This symbol indicates there is a potential UV hazard. Proper

protection must be worn.

This symbol indicates the plumber must use copper piping.

This symbol indicates the marked item could be hot and should not

be touched without care.

This symbol indicates that the system should only be connected to a

properly grounded, grounding-type controller receptacle that is

protected by a Ground Fault Circuit Interrupter (GFCI).

This symbol indicates there is a potential for VERY hot water when

flow is started.

Warning: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

DANGER

Failure to follow these instructions will result in serious injury or death.

• Electric Shock: To avoid possible electric shock, special care should be taken since water is present near the electrical equipment. Unless a

situation is encountered that is explicitly addressed by the provided maintenance and troubleshooting sections, DO NOT attempt repairs yourself,

refer to an authorized service facility.

• GROUNDING: This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric

current to reduce the risk of electrical shock. This system is equipped with a cord having an equipment-grounding conductor and a grounding plug.

The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Improper connection of the equipment-grounding conductor can result in a risk of electrocution. Check with a qualified electrician or service

personnel if you are in doubt as to whether the outlet is properly grounded. DO NOT modify the plug provided with this system – if it does not fit in

the outlet, have a proper outlet installed by a qualified electrician. DO NOT use any type of adapter with this system.

• GROUND FAULT CIRCUIT INTERRUPTER PROTECTION: To comply with the National Electrical Code (NFPA 70) and to provide additional

protection from the risk of electric shock, this system should only be connected to a properly grounded, grounding-type controller receptacle that is

protected by a Ground Fault Circuit Interrupter (GFCI) or to a residual current device (RCD) having a rated residual operating current not exceeding

30 mA. Inspect operation of GFCI as per manufacturer’s suggested maintenance schedule.

• DO NOT operate the disinfection system if it has a damaged cord or plug, if it is malfunctioning or if it has been dropped or damaged in any

manner.

• DO NOT use this disinfection system for other than intended use (potable water applications). The use of attachments not recommended or sold by

the manufacturer / distributor may cause an unsafe condition.

• DO NOT install this disinfection system where it will be exposed to the weather or to temperatures below freezing.

• DO NOT store this disinfection system where it will be exposed to the weather.

• DO NOT store this disinfection system where it will be exposed to temperatures below freezing unless all water has been drained from it and the

water supply has been disconnected.

Safety Information

Especificaciones

Sección 7 Especificaciones

Modelo UV-10

Caudal

Caudal máximo a una dosis de 16 mJ/cm

16 GPM (60 LPM)

Caudal máximo a una dosis de 30 mJ/cm

9GPM (34LPM)

Caudal máximo a una dosis de 40 mJ/cm

7GPM (26LPM)

Entrada/salida NPT de 1,905 cm

Eléctrico

Voltaje CA de 100 a 240 V

Frecuencia 50/60 Hz

Corriente máxima 0,5 Amp

Consumo eléctrico máximo 50 vatios

Potencia de la lámpara 40 vatios

Presión máxima de funcionamiento 125 PSI (862 kPa)

Presión mínima de funcionamiento 4 PSI (27,5 kPa)

Temperatura máxima del aire ambiental 50 ºC (122 ºF)

Temperatura mínima del aire ambiental 0 ºC (32 ºF)

Humedad máxima 100 %

Dureza máxima 120 ppm (7 granos por 3,79 litros)

Nivel máximo de hierro 0,3 ppm

Transmisión UV mínima 75 %

Material de la cámara UV 304 SS

Ciclo de vida nominal de la lámpara 1 año

Certificación del sistema UV