Instructions / Assembly

INSTRUCTIONS FOR ASSEMBLY & USE
1. Insert Handle Section (1) into Extension Section (2) and tighten Connector Screw, using included hex wrench.
2. Insert Extension Section (2) into Driver Section (3) and tighten Connector Screw.
(Use 1 or 2 extension sections depending on the height of the fixture)
3. Choose one of the two Skirt Catchers (5), depending on the size of the bulb to be used, and install by stretching around
the mouth of the Grabber. (It is there to catch the bulb in case it separates from the Grabber.)
4. Insert Grabber (4) into Driver Section (3’s) Geared Driver receptor,
facing down for chandelier bulbs or up for other bulbs.
CHANDELIERS
Extend Grabber over bulb and gently lower onto the bulb.
Turn Handle at bottom of Handle Section (1) in the
direction of unscrewing until bulb is free of chandelier
and can be safely lowered to user. Replace bulb and
secure new bulb firmly into Grabber. Raise HBC and lower
new bulb into place. Rotate Handle in tightening direction
until snug.
DOWN FACING BULBS
Insert Grabber into top of Geared Driver receptor and use
for many bulbs or Use Drive Spindle on the Driver Section
to attach cups, baskets or any other existing bulb
changing technology or utility attachments (dusting,
painting, etc,) that have a standard threaded receptor.
ANY RETURNS
SHOULD
BE SENT TO:
HighLight Bulb Changer
c/o Co-Operations, Inc.
4400 Bankers Circle Suite
Atlanta, GA
NO COD’s, please.
Returns must be made within
2 weeks of purchase.
Qualifying returns will be sent
a check for the amount of the
cost of the HBC.
For Customer Support contact:
[e-mail]
1
2
3
Highlightbulbchanger.com
4
5