INSTALLATION GUIDE Freestanding Bathtubs INSTALLATION GUIDE Freestanding Bathtubs TWO PERSONS REQUIRED Read all instructions carefully before proceeding SAVE THIS GUIDE FOR FUTURE REFERENCE
Thank You For Choosing VANITYART RECOMMENDED TOOLS AND MATERIALS Thank you for choosing a quality VANITYART product. Your confidence in us is of paramount importance to the success of our company. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don’t hesitate to contact us. Our phone numbers and website are listed at the bottom of each page. Thanks again for choosing VANITYART.
1. Installation for Overflow Cover and Drain A A NOTE: If overflow and drain were pre-installed to the tub, then skip this section and go to section 2-leak test before final installation on page 5.(If don't have overflow, please skip this step) C D B Bathtub B C Bathtub D E D Overflow Hardware 6. Apply a fresh bead of clear silicone around the lower rubber gasket (D) then pass it over the bottom of the drain body (B) until it's touching the bottom of the bathtub. 7.
3. INSTALLATION WITH UNDERFLOOR ACCESS Drain Plug Ppo-Up Drain Body Upper Rubber Gasket Lower Rubber Gasket Drain Body Nut Tailpiece (provided by installer) Trap Adapter Floor 1. Clean, level and prepare the floor for installation. Place the tub in the exact installed location on the floor trace the outline of the bathtub with a pencil and mark the drain hole location on the floor. Move the tub away so that the plumbing can be installed. TOP Drain Pipe (provided by installer) 5.
3. INSTALLATION WITH UNDERFLOOR ACCESS 8. Fill the tub with water to the overflow and then drain the tub while inspecting the waste and overflow connection below the floor for any leaks. Access from below will be necessary for this step. 1. Clean, level and prepare the floor for installation. Place the tub in the exact installed location on the floor trace the outline of the bathtub with a pencil and mark the drain hole location on the floor. Move the tub away so that the plumbing can be installed.
Floor Surface 5. Clean the surrounding of the drain pipe with cloth in preparation for setting the drain, the area should be dry and free of any debris. Apply a bead of clean silicone or plumber putty around the drain body and pass it through the drain hole, also apply plumber putty to the washer and slide it over the bottom of the drain body. 8. Flip the tub over and carefully set the tub into position with piece assembly to the waste vent and connect it to the drain. PUTTY 6.
IMPORTANT SAFETY RULESSAFETY RULES ATTENTION! ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB. WARNING The bathtub must be installed and used as described in this manual. Use caution when entering or exiting the bathtub. Do not permit children or persons with infirmities to use the bathtub without the supervision of an adult. People using any medications or having adverse medical history must consult a physician before using the bathtub to avoid potential hyperthermia and possible drowning.
