Owner’s Manual Installation, Operation, Maintenance Instructions & Parts List For Outdoor Use Only MODELS: VBQ-30GB, VBQ-30G, VBQ-36G, VBQ-36SZG, VBQ-42G, VBQ-42SZG, VBQ-56G, VBQ-56SZG
Table of Contents Safety Grill Assembly Operation Care & Maintenance Safety Instructions 3 Basic Rules 4 Safe Location for Grill Use 5 Built In Models 6 Free Standing Models 7 Igniter Battery Installation… 7 Side Shelf Installation… 7 Powering Halogen Lights 8 Gas Requirements & Connections. 9 Leak Testing 12 Lighting the Main Burners 13 Match Lighting 13 Preheating Grill and IR Burner.
Safety Instructions IMPORTANT!!! Read these instructions carefully before installing or operating this gas barbecue. These instructions should be left with the homeowner for future reference. !!!WARNING!!! If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Basic Rules When properly cared for, your VINTAGE Grill will give safe, reliable service for many years. However, extreme care must be used since the grill produces intense heat, which can increase accident potential. When using this appliance, for safety, READ all rules carefully and check local codes. Basic safety practices must be followed, including the following: • Begin by ensuring proper assembly. A qualified technician should perform all other service.
• Do not operate the grill under unprotected combustible construction. Use only in well ventilated areas. Do not use in buildings, garages, sheds, breezeways or any enclosed areas. • Keep the areas surrounding the grill free from combustible materials, trash, or combustible fluids and vapors such as gasoline or charcoal lighter fluids. Do not obstruct the flow of combustion and ventilation air. Keep the back of the cart free and clear from debris. • If the unit is stored indoors ensure that it is cool.
Grill Assembly A BUILT T-IN MODE ELS Before locating your Vintage Grill into i your Non--Combustible eenclosure, com mplete the follow wing steps: 1. Reemove all pack kaging materials. 2. En nsure that the burners are posiitioned correctly on their oriffices, and are fu fully seated ontto their supportts. 3. Po osition the Briq quette trays onto their locating g pins and placce briquettes evvenly across traay. 4. En nsure that NEW W batteries are fitted and the igniter i cap is prroperly installeed.
FREE STANDING MODELS Your Vintage Grill has provision for mounting onto a mobile cart. Contact your Vintage dealer for the appropriate cart for your grill. 1. 2. 3. 4. 5. 6. 7. Remove all packaging materials. Ensure that tile burners are positioned correctly on their orifices, and are fully seated onto their supports. Position the Briquette trays onto their location brackets and place briquettes evenly across tray. (Note: The XBBQ models utilize the V-Flame heat distribution system.
INSTRUCTIONS FOR VINTAGE GRILL HALOGEN LIGHTS A three-pronged extension cord (Not Included) must be attached to the three prong male plug on the back of the grill. It is located on the lower right corner on the back of the grill. This extension cord should be plugged into a nearby outlet. Please see diagram below. This extension cord connection is necessary for the halogen lights to operate.
Gas Requirements & Connections Your grill is setup to use either propane (LP) or natural gas (NAT). Before proceeding, ensure the unit is fitted for the gas supply to be used. Connecting to an improper gas type will result in poor performance and increased risk of damage or injury. Do not attempt to operate the grill on any gas other than what the grill is orificed for and what the regulator is set for.
Figure 2- L.P. Gas Connection. CONNECTING THE GRILL TO NATURAL GAS 1) Before proceeding, ensure the unit is fitted for natural gas. Connecting to an improper gas type will result in poor performance and increased risk of damage or injury. 2) For Natural Gas installations, an installer must supply a gas shutoff valve that is easily accessible to the grill with ease of access for emergency gas shutoff.
Figure 3- Natural Gas Connection Page 11
Leak Testing GENERAL INFORMATION Although all gas connections on your VINTAGE Grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.
Lighting Instructions BEFORE LIGHTING Check gas line/hose for signs of wear, abrasion or cuts. If evidence of deterioration is visible, replace the part prior to use. The pressure regulator and hose assembly supplied with the unit must be used. Never substitute regulators for those supplied with the grill. If a replacement is necessary, contact the factory for proper replacement. Screw the regulator (Type QCC1) into the tank. If you smell gas, check for leaks.
NOTE: To ensure proper spark ignition, do not change gap between the electrode wire and the burner. The optimum gap is preset at the factory between 1/8" and 3/16.' Replace 9V igniter batteries at the first sign of spark weakness. 30" grills require one battery, all others require two. See page 3 for battery replacement instructions. Burner Adjustment Every grill is thoroughly checked for proper lighting and burner flame pattern.
LOW HEAT SETTING ADJUSTMENT Figure 5- Low Heat Adjustment The low heat setting on your grill is preset at the factory. Adjust only if altitude or environmental factors are causing poor low heat performance. Never adjust the burner so low that it may go out during use. Do not operate the grill with the low heat screw removed. Gas can escape and cause a potentially hazardous condition. 1. Follow lighting instructions and allow grill to preheat for three minutes. 2.
BEFORE USING THE GRILL: Make sure the grill has been leak tested and is properly located Remove any packing material. Read and understand the instructions in this manual. Light the grill burners using the lighting instructions. NEVER COOK WITH THE LID DOWN WHEN THE MAIN BURNERS ARE LIT. DOING SO CAN CAUSE THE DELICATE ELECTRONICS ON THE FRONT OF YOUR GRILL TO MELT AND CREATE SERIOUS DAMAGE ON YOUR GRILL. Before each use, turn the control knobs to “High” and preheat the grill for 10-15 minutes.
Cleaning & Maintenance GRILL RACK The round wire grill grates are easily cleaned immediately after cooking is complete and before turning off the flame. Cleaning will be more difficult when the grill has cooled down. Wear a barbeque mitt to protect your hand from the heat. Dip a brass bristle barbeque brush in a bowl of hot soapy water frequently and scrub the hot grill rack. Steam is created as the water contacts the hot grate. The steam assists the cleaning process by softening any food particles.
STAINLESS STEEL ADDITIONAL INFORMATION Your VINTAGE grill is made from commercial quality, stainless steel. After initial usage, areas of the grill may discolor from the intense heat emitted by the burners. This is normal. Minor surface rust may occur in the presence of salt (ocean) water or some cleaning agents that contain chlorine. Wash with warm soapy water and wipe dry with a soft cloth after each use. Due to the nature of its brushed surface, minor scratches may appear with normal use and handling.
Troubleshooting Guide BEFORE CALLING FOR SERVICE If the grill does not function properly use the following checklist before contacting your dealer for service, you may save the cost of a service call and the inconvenience of being without your grill. Additional troubleshooting tips can be found on our website at Http://www.vintageluxuryappliances.
VINTAGE GAS GRILL - OUTDOOR APPLIANCE WARRANTY (RESIDENTIAL USE ONLY) LIMITED TWO-YEAR WARRANTY Outdoor Gas Grills and all their component parts, except as detailed below “**” are warranted to be free from defective materials or workmanship when subjected to normal domestic use for a period of twenty-four (24) months from the date of original retail purchase. Vintage agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.
VINTAGE GAS GRILL - OUTDOOR APPLIANCE WARRANTY REGISTRATION Customer Service: (866) 755-7981 Please visit us at: http://www.vintageluxurygrills.com to register your Vintage product. Please be sure to have the following information: Date of Purchase: Date of Installation: Dealer Whom Purchased: Serial Number & Model No: To obtain service or warranty, you must provide the following information.
