Datasheet

Preliminary
Subject To Change Without Notice
12864Z
- 21 -
12 Precautions for operation and Storage
12.1 Precautions for Operation
(1) Since OLED panel is made of glass, in order to prevent from glass broken, please do
not apply any mechanical shock or impact or excessive force to it when installing the
OLED module. Any strong mechanical impact due to falling dropping etc. may cause
damage (breakage or cracking).
(2) The polarizer on the OLED surface is made of soft material and is easily scratched.
Please take most care when handing.
(3) If OLED surface is contaminated, please wipe it off gently by using moisten soft cloth
with normal ethanol, do not use acetone, ketone, isopropyl alcohol or water. If there is
saliva or water on the OLED surface, please wipe it off immediately.
(4) When handling OLED module, please be sure that the body and the tools are properly
rounded. And do not touch I/O pins with bare hands or contaminate I/O pins, it will
cause disconnection or defective insulation of terminals.
(5) Do not attempt to disassemble or process the OLED module.
(6) OLED module should be used under recommended operating conditions shown in the
specification. Since the higher voltage leads to the shorter lifetime, be sure to use the
specified operating voltage.
(7) Foggy dew, moisture condensation or water droplets deposited on surface and contact
terminals will cause polarizer stain or damage, the deteriorated display quality and
electrochemical reaction then leads to the shorter life time and permanent damage to
the module probably. Please pay attention to the environmental temperature and
humidity.
12.2 Soldering
(1) Use the high quality solder. (60-63% tin mixed with lead)
(2) Iron: no higher than 260
and less than 3~4 sec during soldering.
(3) Soldering: only to the I/O terminals.
(4) Rewiring: no more than 3 times.
12.3 Precautions for Storage
(1) Please store OLED module in a dark place, avoid exposure to sunlight, the light of
fluorescent lamp or any ultraviolet ray.
(2) Keep the environment temperature at between 10°C and 35°C and the relative
humidity less than 60%. Avoid high temperature, high humidity.
(3) That keeps the OLED modules stored in the container shipped from supplier before
using them is recommended.
(4) Do not leave any article on the OLED module surface for an extended period of time.
12.4 Warranty period
VT Co.Ltd. warrants for a period of 12 months from the shipping date when stored or used
under normal condition.