IMPORTANT INSTRUCTIONS & OPERATING MANUAL HOUSELUX 26(EF26T) HOUSELUX 28(EF28T) HOUSELUX 30(EF30T) WARNING Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Fail to do so could result in fire, electric shock, or serious personal injury. CAUTION Keep this owner’s manual for future reference. If you sell or give away this product,make sure this manual accompanies this product.
CONTENTS Important Safety Information ……………………………………………………....................................... 3 Preparation …………………………………………………………………………………………….….…... 5 Product Dimension …………………………………………………………………………………….……. 6 Assembly ……………………………………………………………………………………………….……... 7 Battery Information ………………………………………………………………………………………..… 7 Operation ……………………………………………………………………………………...………………. 8 Control Panel ………………………………………………………………………...………………… 9 Remote Control …………………………………………………………………………………...…..
IMPORTANT SAFETY INFORMATION! WARNING Read all instructions before using this heater! This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this burning heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater, and keep them away from the sides and rear.
heater voids all warranties, and could cause injury. This product is not intended to be a primary heat source. It is for supplemental heat only. INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock! Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside! NEVER modify this heater. Doing so could result in personal injury or property damage. Modification of this fireplace completely voids all warranties.
PREPARATION DO NOT use this Electric Fireplace if any part has been under water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary. Keep plastic wrapping away from children. Unpacking the Electric Fireplace. Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Check the parts list to make sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
PRODUCT DIMENSIONS Fireplace Insert Fireplace Mantel Units:cm Insert Width Insert Height Insert Depth （IW） （IH） （ID） EF26T 68.86 57.40 20.7 EF28T 73.96 64.0 20.7 EF30T 64.26 64.0 20.
ASSEMBLY ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating. Failure to do so could result in electric shock, fire, or personal injury. KEEP drapery and other furnishings at least 3ft /0.9m from the front and sides of the electric fireplace. AFTER installation, ensure that there is ≥0.004 ㎡ ventilation area between inside and outside of fireplace mantel. Your new electric fireplace may be installed virtually anywhere in your home.
OPERATION Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Fail to do so could result in e ectric l shock, fire, serious injury, or death. Power Make sure the Power Switch, located on the control panel, is in the OFF position. Plug the power cord into a 220~240 Volt 8 Amp outlet (see IMPORTANT SAFETY INFORMATION on Pages 3 and 4). Make sure the outlet is in good condition and that the plug is not loose.
Control Panel Located on the right and top side panel of the fireplace. BUTTON NAME POWER SWITCH FUNCTION Turn on the main power supply. A long “beep” sound will be heard when the switch is turned on On Position “I”. Note: The remote control will lost the memory for function settings when the switch is turned on Off Position “0”. The flame will be cycled F1 – F2 – F3 – F4 – F5-Flame Off. FLAME F1 is the less flame,F5 is the biggest flame. The heater will be cycled Low – High – Heater Off.
Remote Control NOTICE: NOTICE: Control panel Power Switch must be ON to use remote control. Aim the remote control at the remote receiver. Make sure you hear a beep each time you press the button! If not, the fireplace will not respond to the signal. , Operation for all functions are same as the buttons on the fireplace.
CARE AND MAINTENANCE ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Cleaning NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or personal injury. Metal: Buff using a soft cloth, slightly dampened with a citrus oil-based product.
SCHEMATIC DIAGRAM
FAQ - FREQUENTLY ASKED QUESTIONS Why does the fan blow before the heat comes on, and after the heater is turned off? Heat and cool gradually. The fan blows when the heater is first turned on, and the heat is still heating up. After the heater turns off, the fan will continue to blow air for 10 seconds. This allows the fireplace to cool slowly, and helps prevent overheating.
TROUBLESHOOTING GUIDE PROBLEM SOLUTION There is no power to the 1. Make sure the power cord is plugged into a functioning and fireplace, or it does not turn on. properly grounded 15 Amp 120V AC electrical outlet. 2. Make sure the Power Switch on the control panel is ON. 3. If the unit had been working, but then turned off by itself, the temperature limiting control may need to be reset. See page 8 for instructions. 4. Check for damage to the power cord or plug. If damaged, DO NOT USE.
LIMITED WARRANTY This warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain one year from the date of purchase. Missing or initially defective parts will be replaced free of charge during the period of this limited warranty. If parts are unavailable, comparable replacement of refund will be given. The original dated sales receipt is required for all warranty claims.
