Use and Care Manual

Legion Furniture

www.legionfurniture.com

Important Note

Important information

Tools which could damage the surface finishing, should not be laid on or in the bath. Bath should

be adequately protected if using hoist or lift. To make sure the bottom of the bath is set on the

floor completely, please note the shrinkage lines, casting marks and blemished on the underside

of the product (where they can’t be seen when turned upright). Please don’t use water above 60℃

which might cause surface cracking. Damage caused by normal wear and tear or improper use

are not covered by the guarantee. Please check the description on the packing matches the item

you have ordered and check the packing visually on damages upon delivery. Let us know directly

by e-mail if there is an issue. If the product is returned, we only accept the original and

undamaged packing. Please ensure that all items are inspected for fault/damage prior to any

installation commencing. Instructions must be adhered to guideline. And we won’t be

responsible for incorrect installation.

The product must be protected from acids, drain cleaner, hair dyes, nail polish remover and

chlorine. Spilled strong chemicals should immediately be flushed with plenty of hot water to

avoid surface damage.

Let us know directly by e-mail if any damage.

Daily care of baths

For matt finish, please use soap and water for baths regular care which will keep mineral marble

smooth and silky. When use a damp cloth or cleaning cloth with a mild abrasive cleaner, please

keep circular motions. This keeps the original appearance of the material, even after prolonged

use.

For gloss finish, we recommend soft bathroom or kitchen cleaner and any abrasive cleaner will

not only damage mental drainer but also the gloss surface over time.

PAGE 1
Legion Furniture www.legionfurniture.com Important Note Important information Tools which could damage the surface finishing, should not be laid on or in the bath. Bath should be adequately protected if using hoist or lift. To make sure the bottom of the bath is set on the floor completely, please note the shrinkage lines, casting marks and blemished on the underside of the product (where they can’t be seen when turned upright). Please don’t use water above 60℃ which might cause surface cracking.
PAGE 2
Legion Furniture www.legionfurniture.com Repair & Maintenance For Matt finish, deep scratches may require flint abrasive paper for the first step. We could use abrasive paper #600 or #800. And then use #2000 for smooth finishing. If choose power tools, please set it on a low speed setting. It would be possible to remove light scratches using daily tools without using abrasive papers. We would use mildly abrasive cream or toothpaste scrub gently with cleaning cloth.