Full Product Manual
Add gasoline
The fuel cap is located on top of the fuel tank. Fill the tank
with fresh unleaded gasoline 87 octane or higher. The tank
is full when you see fuel in the bottom of the fuel lter cup.
DO NOT overll the tank.
3.
Add oil
The oil ll cap is located on the lower engine block to the
right of the recoil start housing. Remove the oil ll cap and
ll with 10w30 oil.
2.
5.
Turn breaker o
The breaker is located on the left side of the front power
panel. Flip the breaker down to prevent accidental load
when starting the generator.
4.
1.
Select Gasoline Fuel
The Fuel Selector is located on the left side of the front
power panel. Flip the switch up to select gasoline as a fuel
source.
Connect propane hose
The LPG Inlet is located on the bottom of the fuel selection
panel. Connect the propane hose to both the inlet and the
propane tank. Open the propane tank.
3.
Add oil
The oil ll cap is located on the lower engine block to the
right of the recoil start housing. Remove the oil ll cap and
ll with 10w30 oil.
2.
5.
4.
1.
Select LPG fuel
The fuel selector is located on the top of the Fuel Selection
Panel. Turn the selector clockwise to select propane.
Turn gas valve o
The gas valve is located on the gas cap. Rotate the valve
counter clockwise to the OFF position.
Turn start switch on
The start switch is located on the left side of the front
power panel next to the low Idle. Press the switch up to
the start position to allow the generator to start.
QUICK START GUIDE (PROPANE)
16