Installation Guide

6060 Boat Rock Blvd SW, Suite 800, Atlanta, GA 30336 USA | Toll Free: 1.855.774.0002 Phone: [phone] Fax: [phone] | dassoXTR.com
Version: November 8, 2018 5:22 PM | Page 1 of 4
Fastening (cont.)
• Use the right screw type based on your wall
substrate. Your wall substrate should be
sturdy enough to support your dassoXTR
facial planks.
• Use 2 screws per eld clip for sot and deck
skirting projects and 1 screw for wainscoting
and interior wall project.
• Use 1 screw per starter clip.
• For shimming, when required due to
inconsistencies in the wall, we recommend
the use of wood/plastic shims behind the clip
that are the same coverage area as the clip
to maintain a stable surface for the clip.
• Always begin clip application at one end and
proceed to the other end.
• Position eld clips so that fasteners are
centered over batten and/or studs, except
where butt joints occur.
• The fastener for penetrating the batten must
be long enough to penetrate the 3/4" 1x2
and sheathing into the stud.
Sot facial side with drill screw and plug